Catalogs >
Rain Bird >
BPES Brass Valves

BPES Brass Valves
1Pages

Catalog excerpts

Valves BPES Brass Valves Valve and PRS-D module must be ordered separately. See pages 62-63 for more information on the PRS-D option. For non-U.S. applications it is necessary to specify NPT or BSP thread type. Flow with or without PRS-D*: 60 to 300 gpm (227 to 1136 l/m); (13.6 to 68.1 m3/h) Pressure: 20 to 200 psi (1.4 to 13.8 bar) Pressure with PRS-D*: Up to 100 psi (6.9 bar) Pressure Requirements using PRS-D*: 15 psi (1.0 bar) inlet pressure above desired outlet pressure Dimensions: Height: 13 5/8" (34.6 cm) Length: 8" (20.32 cm) Width: 7" (17.78 cm) Temperature: 110°F (43° C) maximum Electrical Specifications: Power: 24 VAC 50/60 Hz (cycles/sec) solenoid Inrush current: 0.41 A (9.84 VA) at 60 Hz Holding current: 0.28 A (6.72 VA) at 60 Hz Coil resistance: 28 ohms, nominal U.S. Data — Pressure Loss** HOW TO SPECIFY NOTE: Valve and PRS-D must be ordered separately. See pages 36-37 on how to specify the IC configuration. Metric Data — Pressure Loss** (bar) F l/m Rain Bird recommends flow rates in the supply line not to exceed 7 72 ft/sec (2.29 m/s) in order to reduce the effects of water hammer. For flows below 5 gpm (19.2 l/m, 1.14 m3/h), Rain Bird recommends use of upstream filtration to prevent debris from collecting below the diaphragm. For flows below 10 gpm (37.8 l/m, 2.27 m3/h), Rain Bird recommends that the flow control stem be turned down two full turns from the fully open position.

Open the catalog to page 1

BPES Brass Valves 1Pages

Catalog excerpts

All Rain Bird catalogs and technical brochures

BPES Brass Valves
1Pages