IMMEDIATELY AFTER THE INSTALLATION OF YOUR FLOOR Quick-Step Livyn vinyl floors are ready to be used and don’t need a special surface treatment. Just note that if your floor is glued down to the base floor, you have to take into account the drying time of your glue. Please use recommended Quick-Step Livyn glue and follow the instructions carefully. If your floor is installed floating you can walk on it immediately. Remove all loose debris from the floor with, first, a vacuum cleaner and second, a damp microfiber mop. Use just water until your water is clear and no dirt is left on the floor. Glue, plaster and paint residues should be removed as soon as possible with a cloth. Most residues can be removed with water and a regular vinyl flooring cleaning product. DAILY CARE & MAINTENANCE 1. Remove all loose debris from the floor by using a vacuum cleaner or sweeping brush. Then clean the floor on a regular basis with the Quick-Step Livyn advised cleaning agent diluted in water. Use the cap of the bottle to measure two capfuls of cleaner. Add them to a bucket of lukewarm water. 2. Wipe the floor with a damp, non-fluffy cloth or mop which has been dipped in the water with the cleaning product. 3. Wipe the floor off with a dry cloth until no moisture is visible on the floor. RESIDENTIAL MAINTENANCE INSTRUCTIONS

TROUBLE SHOOTING Scuff marks: Cause: Black streaks usually left by items that have a hard rubber bottom. Solution: Scuff marks can easily be wiped away with the Quick-Step Livyn advised cleaning agent and a sponge. Scratches: Cause: Scratches can appear due to excessive grit and/or dirt on the floor. Solution: Use an appropriate entrance mat to prevent this problem. Also sweep the floor daily when a lot of sand or grid enters the room. Using the Quick-Step Livyn cleaning product can also help to make micro scratches less visible. A deep scratch it can be filled using a special repair kit with...