low pedestal (from 28 to 43 mm) 1 3/32” to 1 11/16” system description Uptec is a patented system composed of only 3 basic elements, designed to create raised outdoor floors. These are height-adjustable polypropylene supports, with tilting head to compensate slope difference up to 5%. By simply blocking the locking ring on the head, you can switch from the self-leveling system to the fixed one. The accessory applied above is made of rubber to ensure an anti-noise and anti-slip system. UPTEC - SUPAL PRODUCT DESCRIPTION The Uptec SUPAL support is adjustable in height from 28 to 43 mm (13/32” to 1-11/16”), with a base with a diameter of 190 mm (7-31/64”) and a head of 130 mm (5-1/8”). On the head it is possible to apply the accessories for standard installations (for 2 or 4mm joints; 5/64” or 5/32”), for laying with aluminum joist or for laying with wooden joist. Holes have been made on the base to allow the water to flow out, and on the lower side 4 pre-engraved lines for any cuts. technical drawings SUPAL Minimum height SUPAL Maximum height SUPAL 130 mm - 5-1/8” 190 mm - 7-31/64” INSTALLATION EXAMPLE SUPAL

SUPAL CODE Models Composition: 80% recycled content, 100 recyclable Tested at temperautres: -20° and 80° (-4°F- 176°F) Fire resistance: HB in compliance with the UL94 regulation Tests performed by the University of Trento. foreign materials. Set the pedestals on cement, concrete, EPDM, rubber, single-layer, other roofing systems, or directly on insulating materials, checking the compressive strength of the support material. Check that the laying surface complies with the drawing specifications and that there is an adequate drainage system. ADJUSTMENT KEY SUPAK The 3in1 adjustment key has been...