Datasheet STAIRTEC SWR PRODUCT DESCRIPTION Modern and sophisticated, STAIRTEC SWR stainless steel non-slip buttons are a safe and innovative alternative to linear profiles. The round, grooved buttons slightly protrude 1,6 mm on the stair or floor surface. Elegantly designed, STAIRTEC SWR buttons can be used to customize wood and natural stone staircases. Installation and assembly can be made on or off-site. To install on wood flooring, simply drill a 6,5 mm opening and hammer the button in place. The buttons should be spaced 70 mm on center. To install on natural wood or ceramic tile flooring, simply drill a 7 mm opening and fasten the button with appropriate adhesive. The buttons should be spaced 70 mm on center. TECHNICAL FEATURES Hole: Wood 6,5 mm Hole: Stone 7mm MATERIAL DESCRIPTION Stainless Steel Steel profiles are made by cold forming sheets of constant thickness, thus differing from the corresponding aluminum and brass versions made by hot extrusion, while maintaining their application and dimensional characteristics. Stainless steel effectively resists high mechanical stress and is particularly suitable for use in the chemical, food, and hospital sectors, where hygiene, durability, and chemical resistance are essential. Normally produced with a semi-gloss finish, a brushed finish can also be achieved by partially removing material using rotating nylon and quartz fiber brushes. This process gives the surface a matte appearance without altering its characteristics. STAINLESS STEEL AISI 303 – EN X 5 CrNi 18 10 – DIN 1,4305: This steel belongs to the AUSTENITIC category and is the most widespread and commonly used alloy for products requiring high technical and performance characteristics. It is highly resistant to most chemical agents but may stain or darken superficially; a standard polishing product is sufficient to restore its original appearance.

positive profile stairtec >> SWR in Stainless Steel AISI 303 - DIN 1.4305 - Polished 1. Depending on the covering (ceramic/stone or wood) prepare holes with a diameter of 7 mm or 6.5 mm (wood) every 70 mm; 2. Insert the anti-slip pin and fix it with a adhesive suitable for the support (FIXXTEC); 3. Use a rubber mallet to drive the pin in all the way; 4. Immediately remove any adhesive residue that may come out of the edge. STAINLESS STEEL: Stainless steel is easy to clean and very hygienic because of its smooth, nonporous surface, which hinders the growth of bacteria. To keep it in good condition,...

BILL OF QUANTITIES ITEM Supply and installation of profile in __________________________ (material), with finish ____________________________ _________________ (see Material Description section) with characteristic size __________________ mm. Family type _________________________ from the Profilitec company as a non-slip pin to be supplied and installed properly, following the methods and fields of application suggested by the manufacturer. Profile length: 2700 mm Profile SKU: ___________________________ Material: ____________________________ €/m Installation: ________________________________...