profilit.ec positive profile STAIRTEC SW 10 AS is an innovative, silver anodized aluminum non-slip profile: an excellent and durable alternative to adhesive mineral grain strips. The grooved, thin, non-slip T-shaped section can be integrated to natural stone and wood stairs. Install the profile off-site. The primary aluminum alloy EN AW-6060 in T6 temper is suitable for complex extrusions, offering high strength and an excellent natural surface finish that lends itself well to subsequent finishing processes. ANODIZED ALUMINUM: The anodic oxidation process provides protection against corrosion caused by atmospheric agents, without involving galvanic treatments. According to the EN 12373 standard, the profiles are treated with preventive processes that make them uniformly opaque, subsequently they are coloured through an electro-chemical oxidation process in the standard colours Silver, Gold, Bronze, Copper and Titanium with a thickness of up to 10 microns. stairtec >> SW 10 AS in Anodized Aluminum

APPLICATION 1. Cut the profile to the required length; 2. Make sure that the groove or gap to be filled is the right size for the profile to fit into. 3. In general, for wooden floors calculate 0.5 mm less than the joint, for stone and ceramic floors the measurement is that of the joint; 4. Apply the adhesive (FIXXTEC) in the groove; 5. Position the profile by inserting it with uniform pressure and using a rubber mallet; 6. Remove any adhesive residue from the profile immediately. N.B.: Aluminum profiles offer limited resistance to alkaline substances, so their use must be evaluated according...