profilit.ec positive profile STAIRTEC SA is an anodized aluminum profile with a non-slip mineral grain strip that ensures high safety standards. This profile is an excellent choice for pre-existing stairs in commercial and industrial renovations. The carved internal cavity soundly adheres to existing stairs, perfect for retrofitting damaged stairs and concealing edge imperfections. STAIRTEC SA profiles can be installed with adhesive or flathead screws and then covered with the mineral grain strip. To be used in combination with SWH19. To be used in combination with SWH50. MATERIAL DESCRIPTIONAluminum The primary aluminum alloy EN AW-6060 in T6 temper is suitable for complex extrusions, offering high strength and an excellent natural surface finish that lends itself well to subsequent finishing processes. ANODIZED ALUMINUM: The anodic oxidation process provides protection against corrosion caused by atmospheric agents, without involving galvanic treatments. According to the EN 12373 standard, the profiles are treated with preventive processes that make them uniformly opaque, subsequently they are coloured through an electro-chemical oxidation process in the standard colours Silver, Gold, Bronze, Copper and Titanium with a thickness of up to 10 microns.

stairtec >> SA in Anodized Aluminum - not Adhesive 1. Check that the substrate is solid, flat, clean, degreased and dry, verifying that the application temperature is not lower than 15°C in case of gluing; 2. Cut the profile to the required length; 3. Apply the adhesive (FIXXTEC) to the part of the profile to be adhesived, or remove the protective paper from the adhesive for self-adhesive versions, and position the profile correctly without further adjustments; 4. Apply the profile with uniform pressure without hammering; 5. Remove any adhesive residue from the profile immediately. N.B.: Aluminum...

CLEANING AND MAINTENANCE ALUMINIUM: Aluminum requires no special maintenance. For cleaning, use colorless alcohol diluted in water or neutral detergents, avoiding acidic ones (e.g., hydrochloric or hydrofluoric acid); use non-abrasive sponges or cloths to avoid damage. We recommend not applying cleaners directly to surfaces. After cleaning, rinse with water and dry immediately with a soft cloth. Avoid polishes. Quickly remove residual cement or grout to protect the surface. WARNINGS These profiles must be handled with care, taking care to use cut-resistant gloves. The instructions and requirements...