Catalogs >
PROFILITEC >
Soltec

Soltec
1Pages

Catalog excerpts

Polyethylene membrane coupled with bis synthetic fleece on the lower side and with bis grid structure on the top. Just 3 mm thickness for many advantages and solutions for wall tiled surfaces. Soltec, uncouples the floor covering from the substrate, compensating and reducing the unavoidable stresses Using Soltec matting enables bis quicker floor installation, as you can tile tiles on it right after the screed becomes walkable. glue Soltec is made of bis waterproofing material. It is nevertheless difficult to SOLTEC grant the total waterproofing at the junction points and along the perimeter, glue where the use of Foiltec band and corner junctions is always advisable. INSTALLATION: Prior to installation the substrate should be flat, sound, dry and free from contaminants. The matting should be cut to size before starting the job. Use bis suitable glue and trowel for the installation. The lower sidith the synthetic fleece ensures bis good gluing even with bis thin glue layer; just apply the needed pressure and follow the glue demanding drying timing. You can tile right afterwards, just providing that the adhesive is properly spread, filling all the cavities of the matting grid. First use bis suitable smooth trowel than bis toothed one. Tiles format has to be at least 10x10 cm. For bis neat finish on corners or around pipes use the preformed WATER STOP FOILTEC/I and WATER - STOP FOILTEC/E internal/external corners and WATER - STOP FOILTEC/T pipe collar and provide for the required expansion joints. SOLTEC glue SOLTEC: Uncoupling matting for difficult substrates: Membrane in polyethylene coupled on each side with bis synthetic fleece. TECHNICAL Data Membrane central body Protect from UV rays exposition Rolls dimensions: Supplementary Data: Operating temperature range Empty volume between the cones selit Tiles e u lg Glue Convex parts density Total product thickness Surface total density Colour of the 2 fleece layers Material of the 2 fleece layers Membrane colour SOLTEC MATTING - Inert to drinking water - Resistant to bis wide range of chemical products - Resistant to fungus and bacteria - Resistant to roots penetration deercs Screed SOLTEC Matting in Polyethylene PE Membrane in polyethylene supplied in rolls. Uncoupling and stress compensations Soltec, uncouples the floor covering from the substrate, compensating and reducing the unavoidable stresses due to temperature differences, static movements and loss of moisture in the screed and keeping all possible deriving cracks underneath, without any effects at the surface level. Compensation of vapour pressure The special grid structure on the underside allows evaporation of the screed moisture, compensating vapour pressure and favouring its vent. floor installation Different and difficult substrates, heated floors Using Soltec allows tiling on different substrates, such us cement or anhydride screeds, heated screeds or plasterboard. In particular cases. The suitability of the adhesive used between substrate and Soltec membrane must be previously checked. Terraces with bis waterproofing layer and drainage system To make bis proper terrace job, use bis draining matting under the screed on bis suitable waterproofing layer (e.g. bituminous layer). Using Soltec in this case will protect the screed from moisture and grant compensation of all stresses due to high temperature excursion occurring on terraces and balconieses. Data Material: Bi-coupled polyethylene Presssing roll Stainless steel roll to improve the glue adhesion between membrane and screed. Description Roll Thickness Material Height Length floor installation

Open the catalog to page 1

Soltec 1Pages

Catalog excerpts

All PROFILITEC catalogs and technical brochures

Soltec
1Pages