Catalogs >
PROFILITEC >
SET+MAGtec

SET+MAGtec
1Pages

Catalog excerpts

Polypropylene supports for laying of floating tiles and floor coverings. Good resistance to ice and atmospheric agents. It is an easy to use system that can adjust the covering to different heights thanks to the available shims. Ideal for large balconies, terraces, verandas walkways and roof gardens. Placed directly onto the sloping bituminous waterproofing layer they provide an effective drainage system and ensure maintenance of the waterproofing layer over time. A magnetic device for creation of a discrete tiled acces panel with four magnetic tabs placed on the corners. It is a universal application suitable for all types of tiles, ensuring a neat finish. Can be easily removed and replaced at all times. INSTALLATION: Determine on the wall the inspecting panel position and size. The panel sides should correspond to square modules of one or more tiles connected with a support base. Glue the 4 fixing plates on the wall covering tile rear side, along the inspecting panel opening. Make an access panel by fixing the four magnets with adhesive, one on each corner, on the single tile or tile-panel created previously, checking that they are well aligned with the plates on the wall. Make sure that the adhesive is completely dry before placing the inspection panel back on the wall. If necessary seal along the inspecting panel perimeter with silicon. This seal may subsequently be cut to allow removal of the panel. Plastic support discs for floating stone tiles Manufactured in Polypropylene. Drilled in the lower part to enable water drainage. They prevent cracking of the tiled floor due to ice or water seepage. Simple to remove, they allow easy repair and upgrading of the damaged bituminous layer. Any required height or possible subfloor unevenness can be matched with the available shims. Magnetic tabs for tile panel - wall inspection Metal tabs with magnetic elements fixed to them. 4 tabs with magnets plus 4 perforated backing fixing plates. Description Material: Galvanised steel SUPPORT for cement laid floating tiles Aids installation by allowing the cement to be accurately placed beneath the tiles while fixing the tiles at the edges and ensuring an adequate amount of drainage beneath the tiles. Cross-shaped 3 mm thick spacers available, to apply in the central part. accessories floating floors H=mm Material: Polypropylene 20 3x15 N.B.: 8021 Thickness 3 mm, Height 15 mm Material: Polypropylene magnets for tiled panels accessories

Open the catalog to page 1