Datasheet ROUNDCORNER RO PRODUCT DESCRIPTION ROUNDCORNER RO is a complete range of rounded corner profiles designed to protect exposed external corners and conceal chipped tiled corners. Typically used in heavy trafficked commercial and industrial settings, this profile contains internal, shock-absorbing self-adhesive strips. TECHNICAL FEATURES Length: 2,70 meters Stainless Steel - Brass MATERIAL DESCRIPTION Stainless Steel Steel profiles are made by cold forming sheets of constant thickness, thus differing from the corresponding aluminum and brass versions made by hot extrusion, while maintaining their application and dimensional characteristics. Stainless steel effectively resists high mechanical stress and is particularly suitable for use in the chemical, food, and hospital sectors, where hygiene, durability, and chemical resistance are essential. Normally produced with a semi-gloss finish, a brushed finish can also be achieved by partially removing material using rotating nylon and quartz fiber brushes. This process gives the surface a matte appearance without altering its characteristics. STAINLESS STEEL AISI 430 – EN X 8 Cr 17 – DIN 1,4016: Steel belonging to the FERRITIC category, although considered stainless, in the presence of particularly aggressive products it can stain the surface and be contaminated by oxidation triggers generated by other materials.

positive profile roundcorner >> RO in Stainless Steel AISI 430 - DIN 1.4301 - SelfAdhesive The primary aluminum alloy EN AW-6060 in T6 temper is suitable for complex extrusions, offering high strength and an excellent natural surface finish that lends itself well to subsequent finishing processes. ANODIZED ALUMINUM: The anodic oxidation process provides protection against corrosion caused by atmospheric agents, without involving galvanic treatments. According to the EN 12373 standard, the profiles are treated with preventive processes that make them uniformly opaque, subsequently they are coloured...

positive profile roundcorner >> RO in brass- adhesive 1. Check that the substrate is solid, flat, clean, degreased and dry, verifying that the application temperature is not lower than 15°C in case of gluing; 2. Cut the profile to the required length; 3. Apply the adhesive (FIXXTEC) to the part of the profile to be adhesived, or remove the protective paper from the adhesive for self-adhesive versions, and position the profile correctly without further adjustments; 4. Apply the profile with uniform pressure without hammering; 5. Remove any adhesive residue from the profile immediately. N.B.: Aluminum...

WARNINGS These profiles must be handled with care, taking care to use cut-resistant gloves. The instructions and requirements contained herein, while based on our experience, are to be considered purely indicative and must be confirmed by exhaustive practical applications. Profilitec declines all responsibility for any damage to persons or property resulting from improper use of the product. The user is responsible for determining whether or not the product is suitable for use and assumes all responsibility for any damage resulting from incorrect installation of the material. BILL OF QUANTITIES...