profilitec positive profile ROUNDCORNER RE is a rounded corner profile conceived to protect exposed external tile corners. The profile is installed on site, laying the tile flush against the perforated flanges and creating a perfectly leveled corner. Typically used in heavy trafficked areas in public spaces such as hospitals, food processing plants and public bathrooms. Steel profiles are made by cold forming sheets of constant thickness, thus differing from the corresponding aluminum and brass versions made by hot extrusion, while maintaining their application and dimensional characteristics. Stainless steel effectively resists high mechanical stress and is particularly suitable for use in the chemical, food, and hospital sectors, where hygiene, durability, and chemical resistance are essential. Normally produced with a semi-gloss finish, a brushed finish can also be achieved by partially removing material using rotating nylon and quartz fiber brushes. This process gives the surface a matte appearance without altering its characteristics. AISI 304 STAINLESS STEEL - EN X 5 CrNi 18 10 - DIN 1.4301: This steel belongs to the AUSTENITIC category and is the most widespread and commonly used alloy for products requiring high technical and performance characteristics. It is highly resistant to most chemical agents but may stain or darken superficially; a standard polishing product is sufficient to restore its original appearance. roundcorner >> RE in Stainless Steel AISI 304 - DIN 1.4301 - 25x25

APPLICATION 1. Choose a profile according to tile thickness and desired finish; 2. Cut to the desired length; 3. Spread the adhesive in the profile application area with the help of a notched trowel; 4. Position the profile by pressing it so that it is embedded in it, and then spread the resulting excess adhesive on the surface of the flap; 5. Lay the tiles, taking care to align them with the profile and leave a gap of about 2 mm. The profile laid properly should be installed in the same plane as the tile; 6. To apply special pieces such as external and internal corners, joints, and end caps,...