Catalogs >
PROFILITEC >
Profiledrain K

Profiledrain K
1Pages

Catalog excerpts

The DRAIN system for shower trays is completed by 3 new profiles for the wall tiling within the shower space. Floor to Floor Wall to wall floor to wall Tile thickness These profiles facilate the work of the floor layer. They manage the transition between the slope of the shower area and the surrounding wall and floor covering. Shower tray depth The technical solution consists of two conical profiles, each one with a right side and a left side and a front end profile parallel to the linear drain on the back wall. Note: 1 - According to the depth of the shower area, the conic profiles (n°.1 and n°.2) must be cut from the wider end (B 35 mm). 2 - Below is a table to help identify the height of the TR according to the tile height. We also indicate according to the depth of the shower area and the tile height, which version of the frontal profile (n. 3) is to be used, A 28 mm or A1 34 mm. EXAMPLE: Shower tray depth: 1000 mm Tile thickness: 10/11 mm TR to be inserted in the conical profile at floor 1 - Conical profile floor to floor transition KP35IS135DX + TR A÷B 3 - Front end profile floor to wall transition KF10/34IS135 draining systems sloping profiles Material: Brushed Stainless Steel AISI 304 2 - Sloping profile for installing linear drain as floor to wall transition Conical profile to connect wall covering to the floor area following a slope of 2%. A 8 mm, B 35 mm. Left and right version. Lenght 1,35 m to be cut if needed on site. A conical brushed steel profile in Aisi 304 with A at 8 mm and B at 35 mm giving a 2% gradient. Material: Brushed Stainless Steel AISI 304 3 - Front end profile to install the wall covering behind the linear drain. Frontal profile to connect wall to floor on the side of the wall parallel to the linear drain. Available in two heights: A 28 mm or A1 34 mm for tile height 8/10/12,5 mm. Lenght 1,35 m to be cut on site. 2 - Conical profile floor to wall transition KR80IS135SX 1 - Sloping profile for installing linear drain as a floor to floor transition A conical brushed steel profile to be cut on site according to lenght of the slope required (2% gradient) to make a transition between the shower area and the surrounding floor space. A conical brushed steel profile in Aisi 304 with A at 8 mm and B at 35 mm giving a 2% gradient. Standard lenght 1,35 m which can be cut on site. This profile needs to be use inserting in our TR 6, 8, 10, 11, 12,5 mm- according to tile heightpolished steel profile in 2,7 m or 1,35 m. Material: Brushed Stainless Steel AISI 304 sloping profiles draining sys

Open the catalog to page 1