Datasheet PLANO BF PRODUCT DESCRIPTION Patented Plano Design baseboards are designed to fully integrate into the wall, becoming a smooth level transition between the wall and floor covering. The base track is installed into the wall structure, flush with the plaster or drywall; the finishing profile seamlessly interlocks into the base. A horizontal, 5mm gap between the wall and finishing profile is a distinctive design element that also adapts to floor level differences of up to 5mm. Plano Design, a modern design system. TECHNICAL FEATURES Length: 2,70 meters MATERIAL DESCRIPTION Aluminum The primary aluminum alloy EN AW-6060 in T6 temper is suitable for complex extrusions, offering high strength and an excellent natural surface finish that lends itself well to subsequent finishing processes. ANODIZED ALUMINUM: The anodic oxidation process provides protection against corrosion caused by atmospheric agents, without involving galvanic treatments. According to the EN 12373 standard, the profiles are treated with preventive processes that make them uniformly opaque, subsequently they are coloured through an electro-chemical oxidation process in the standard colours Silver, Gold, Bronze, Copper and Titanium with a thickness of up to 10 microns. POWDER COATED ALUMINUM: Powder coating begins with a chromium phosphate pre-treatment, followed by electrostatic application of polyester powders that offer high resistance to U.V. rays and atmospheric agents. The entire surface of the profile is coated with an average thickness of approximately 60 microns. A hot cross-linking polymerization process is then carried out to ensure maximum chemical and mechanical resistance. WOOD: Natural wood profile assembled with an aluminum base profile. The wood must be treated with appropriate varnishes or protective oils to achieve the most suitable color.

positive profile plano >> BF - TOP in Anodized Aluminum for BF 600 plano >> BFC Junction in Anodized Aluminum for baseboard Plano Design plano >> BF - TOP in Powder Coated Aluminum for BF 600 plano >> BFC Junction in Powder Coated Aluminum for baseboard Plano Design APPLICATION 1. Check that the substrate is solid, flat, clean, degreased and dry, verifying that the application temperature is not lower than 15°C in case of gluing; 2. Cut the profile to the required length; 3. Secure the profile or its profile support base using wall plugs and countersunk screws. Alternatively, if the wall substrate...

CLEANING AND MAINTENANCE ALUMINIUM: Aluminum requires no special maintenance. For cleaning, use colorless alcohol diluted in water or neutral detergents, avoiding acidic ones (e.g., hydrochloric or hydrofluoric acid); use non-abrasive sponges or cloths to avoid damage. We recommend not applying cleaners directly to surfaces. After cleaning, rinse with water and dry immediately with a soft cloth. Avoid polishes. Quickly remove residual cement or grout to protect the surface. WARNINGS These profiles must be handled with care, taking care to use cut-resistant gloves. The instructions and requirements...