Catalogs >
PROFILITEC >
Leveltec LEV

Leveltec LEV
1Pages

Catalog excerpts

Leveltec is a revolutionary tiling system with no current equivalents in the market. The first leveling system that requires no tools for both installation and disassembly. It is an automatic screw system that works with a simple click. The product is laid in dry conditions, without need of adhesives. The system consists of a reusable cap and a tie-base that ensures a tile joint of 2 mm (according to UNI 11493 standard). click & level Leveltec Laying instructions The quantity of Leveltec depends on the size of the tile (AxB) and it can be deduced from the scheme below. + The leveler does not require pliers or unscrew-drivers. + Easy positioning without screwing. + Automatic ejection of the thread. + 50% time saving compared to other systems. + Easy leveling adjustment with few degrees of rotation. + No need of further side action on the tiles , only a proper vertical pressure. + Suitable for tiles from 3,5 to 20 mm. + Nominal width of the joint 1,7 mm (UNI 11493). + Compatible with standard cross-shaped tile spacers to match with bigger tile joints. + Reduced tie-base not to interfere with the thickness of the glue. + It keeps the tiles in the correct position during the glue drying and shrinkage. + A perfect system for big formats. + Evolution Laying scheme to be observed for correct use of Leveltec. example (30x30) = 44 pieces / mq example (60x60) = 11 pieces / mq example (45 x45) = 20 pieces / mq N.B. The tie-base allows tiling according to the UNI 11493 standards ( 2 mm) Place the Tie-base under the floor or wall covering. Its reduced thickness and the small size of the base does not interfere with the glue and determines a nominal 1,7 mm joint which is in line with the UNI 11493 standard. Insert the cap vertically until it touches the tile without screwing. Just one click to fit automatically in the thread with considerable optimization of the installation time. accessories levelling system Level the tiles with a rotation of a few degrees, allowing you to get the perfect alignment of the surface. Remove the Leveltec when the glue is completely dry . Use a rubber mallet and act on the cap. Be careful to follow the same direction of the joint. The threaded stick breaks at the bottom, leaving no residue. Press on the remaining thread to release the cap that will allow the thread to get out without unscrewing. The cap is reusable for subsequent applications. The tiles, in particular those of big format, during the laying may not be perfectly calibrated. In the drying step of the adhesive there may be shrinkages and sinkings that are not evident during the installation. The use of the Leveltec allows the perfect alignement of the upper surface of the floor with the surface of the wall, compensating not the nonplanarity and the following glue shrinkage. levelling system accessories

Open the catalog to page 1