Datasheet KERACORNERCO KERACORNER CO is a complete range of rounded corner profiles designed to protect exposed external corners and conceal chipped tiled corners. Typically used in heavy commercial and industrial settings, this profile contains internal, shock-absorbing self-adhesive strips. Available in a variety of sizes, materials and finishes, it meets all technical requirements. Stainless Steel - Brass H1 = 2,5 mm MATERIAL DESCRIPTIONSteel Steel profiles are made by cold forming sheets of constant thickness, thus differing from the corresponding aluminum and brass versions made by hot extrusion, while maintaining their application and dimensional characteristics. Stainless steel effectively resists high mechanical stress and is particularly suitable for use in the chemical, food, and hospital sectors, where hygiene, durability, and chemical resistance are essential. Normally produced with a semi-gloss finish, a brushed finish can also be achieved by partially removing material using rotating nylon and quartz fiber brushes. This process gives the surface a matte appearance without altering its characteristics. AISI 304 STAINLESS STEEL - EN X 5 CrNi 18 10 - DIN 1.4301: This steel belongs to the AUSTENITIC category and is the most widespread and commonly used alloy for products requiring high technical and performance characteristics. It is highly resistant to most chemical agents but may stain or darken superficially; a standard polishing product is sufficient to restore its original appearance.

positive profile MATERIAL DESCRIPTIONAluminum The primary aluminum alloy EN AW-6060 in T6 temper is suitable for complex extrusions, offering high strength and an excellent natural surface finish that lends itself well to subsequent finishing processes. ANODIZED ALUMINUM: The anodic oxidation process provides protection against corrosion caused by atmospheric agents, without involving galvanic treatments. According to the EN 12373 standard, the profiles are treated with preventive processes that make them uniformly opaque, subsequently they are coloured through an electro-chemical oxidation process...

APPLICATION 1. Check that the substrate is solid, flat, clean, degreased and dry, verifying that the application temperature is not lower than 15°C in case of gluing; 2. Cut the profile to the required length; 3. Apply the adhesive (FIXXTEC) to the part of the profile to be adhesived, or remove the protective paper from the adhesive for self-adhesive versions, and position the profile correctly without further adjustments; 4. Apply the profile with uniform pressure without hammering; 5. Remove any adhesive residue from the profile immediately. N.B.: Aluminum profiles offer limited resistance...

BILL OF QUANTITIES ITEM Supply and installation of profile in __________________________ (material), with finish ____________________________ _________________ (see Material Description section) of characteristic size __________________ mm, with widely rounded corners and concave internal part for better glue grip and better closing support of the profile with the wall. Family type _________________________ from the Profilitec company as a closing and protection profile for the corner of the covering even after installation, to be supplied and installed according to the rules of the art, respecting...