Catalogs >
PROFILITEC >
Jointec GS

Jointec GS
1Pages

Catalog excerpts

Modular high width structural joints as provided by standards for seismic risk areas. The remarkable width to cover reduces their load resistance, they are nevertheless suitable for pedestrian and small trolleys passage, like stretchers or supermarket trolleys. They are installed over the spaces existing between two semidetached parts of a building of smaller entity or between different beam bays. They can connect and close these inter-spaces adjusting themselves up-wards, downwards and even transversally, according to the shrinkage-settlement movements of the whole building, either cyclic or permanent. INSTALLATION: • Slip the rubber infill into the metal insert before aligning the expansion joint in site. • It is advisable to protect the rubber with some adhesive tape to avoid any cement spot. • Fasten the insert into the substrate, through the holes under the rubber, the suitable fixing plugs (7 each linear meter, i.e. one every 30 cm proceeding parallel on the two sides). JOINTEC GS 1000 AN* Aluminium gap width 100 mm Extruded aluminium profile. Good mechanical and chemical resistance over time. Highly elastic double synthetic rubber insert of 37 mm. Insert: standard version or smooth version available on request (pag. 179). H=mm L=mm L1=mm Material: Aluminium extruded Finish: Natural (AN) Insert: Resinprene Black (P51 - suggested), Cement grey (P23) Length: 4,00 metres *”S” for the smooth insert version expansion joints seismic expansion joint

Open the catalog to page 1