Catalogs >
PROFILITEC >
Jointec GM

Jointec GM
1Pages

Catalog excerpts

Modular structural joint adjustable to different heights with visible upper part in either brass or aluminium and lower module in aluminium. Designed to bear structural movements of large sized buildings. They are installed over the spaces existing between two semi-detached parts of a building of smaller entity or between different beam bays. They can connect and close these inter-spaces adjusting themselves up-wards, downwards and even transversally, according to the shrinkage-settlement movements of the building, either cyclic or permanent. Within the flooring bays frame created with the structural joints, a further surface subdivision with a suitable pattern of movement joints should be always provided for. See relevant indications on page 263. L Illustrated scale dimension 1:2 (GM 500*) JOINTEC GM/GML-ON* Brass 50 and 60 mm width Extruded profile joint with visible top part in brass and inferior part in aluminium. High resistance to chemical agents and mechanical impact over time. Suitable for both indoor and outdoor laying. Highly elastic 37 or 47 mm wide synthetic rubber insert. Out-of-standard heights can be supplied on request thanks to the system modularity. Insert: standard version or smooth version available on request (pag. 179). JOINTEC GM/GML-AN* Aluminium 50 e 60 mm width Extruded profile joint entirely in aluminium. Good resistance to chemical agents and mechanical impact over time. Highly elastic 37 or 47 mm wide synthetic rubber insert. Out-of-standard heights can be supplied on request thanks to the system +6 / -7 +5 / -5 modularity. Kg 4000 Insert: standard version or smooth version available on request (pag. 179). JOINTEC GM/GML-IL* Stainless steel 50 e 60 mm width Aluminium profiles with a stainless steel covered aluminium structure for improved aesthetics, durability and increased resistance to most diluted chemical products. The profile is not perfectly corresponding with the above section. Insert: standard version or smooth version available on request (pag. 179). Material:Brass extruded 35 Finish: Natural (ON) 50 75 Insert*: Resinprene - Black (P51), Cement grey (P23) Length: 3,00 metres *”S” for the smooth insert version Material:Brass extruded Finish: Natural (ON) Insert: Resinprene - Black (P51), Cement grey (P23) Length: 3,00 metres Material: Aluminium 35 Finish: Natural (AN) 50 75 Insert*: Resinprene - Black (P51 - suggested), Cement grey (P23) Length: 3,00 metres *”S” for the smooth insert version Material: Aluminium Finish: Natural (AN) Insert: Resinprene - Black (P51 - suggested), Cement grey (P23) Length: 3,00 metres 35 Material: Aluminium + Stainless steel AISI 304 50 Finish: Polished (IL) 75 Insert*: Resinprene - Black (P51 - suggested), Cement grey (P23) Length: 2,70 metres *”S” for the smooth insert version Material: Aluminium + Stainless steel AISI 304 Finish: Polished (IL) Insert: Resinprene - Black (P51 - suggested), Cement grey (P23) Length: 2,70 metres structural modular expansi

Open the catalog to page 1