profilit.ec positive profile COVERTEC SP is a profile designed to join two adjacent existing floors at the same height but it can cover imperfections in cutting or slight variations of height to be found on a tiled floor joining to a wooden one for example. Thanks to its shape, available in 3 different widths, this profile helps floor coverings to maintain the minimum distance thus acting also as a dilatation joint.

positive profile MATERIAL DESCRIPTIONStainless Steel Steel profiles are made by cold forming sheets of constant thickness, thus differing from the corresponding aluminum and brass versions made by hot extrusion, while maintaining their application and dimensional characteristics. Stainless steel effectively resists high mechanical stress and is particularly suitable for use in the chemical, food, and hospital sectors, where hygiene, durability, and chemical resistance are essential. Normally produced with a semi-gloss finish, a brushed finish can also be achieved by partially removing material...

positive profile covertec >> SP in Anodized Aluminum covertec >> SP Embossed Painted Aluminum covertec >> SP in Wood Effect Aluminum 0 SELFLINE/KIT PRE-CUT 0 CURVELINE/BENDABLE MATERIAL DESCRIPTIONBrass Profiles made from CW618N (EN 12167) brass alloy are characterized by high resistance to mechanical stress, making them particularly suitable for heavy-traffic applications, such as industrial settings and at expansion joints. Brass is resistant to most chemical agents commonly encountered during the installation of ceramic coverings. However, in the presence of humidity or aggressive substances,...

APPLICATION 1. Choose the SP profile in the desired material and finish considering a lateral overlap of 2/3 mm; 3. Thoroughly clean the surfaces that will be covered by the profile after installation; 4. Fill the joint space with FIXXTEC or with the adhesive used for laying the floor; 5. Sink the profile into the adhesive, making sure that both lateral overlaps of the profile rest on the coverings to be joined; 6. Apply and maintain uniform pressure for a few minutes along the entire profile to optimize adhesion to the installation surface. N.B.: Aluminum profiles offer limited resistance to...

WARNINGS These profiles should be handled with care, using cut-resistant gloves. The indications and prescriptions herein, while corresponding to our experience, are to be considered purely indicative and must be confirmed by exhaustive practical applications. Profilitec declines any responsibility for any damage to people or things resulting from improper use of the products. The user is required to determine whether or not the product is suitable for use and assumes all responsibility arising from incorrect installation of the material. BILL OF QUANTITIES ITEM Supply and installation of a profile...