prof ill ^ec positive profile COFLEX CE is a synthetic resin movement joint designed to subdivide large tile bays. The profile size is chosen according to the tile thickness and should remain 5 +/- 1 mm below the floor elevation. The joint must be laid in correspondence with joints in the underlying substrate. Exclusively suitable for pedestrian traffic, this profile provides limited protection to the tile edges and compensates slight differential movement due to substrate contraction and expansion. Install with thin-set mortar. RESINIL Thermoplastic synthetic resin for COEXTRUSION: Made from primary resin whose composition based on Polyvinyl Chloride characterizes it for high resistance and optimized compatibility with regards to long-lasting adhesion with plasticized resins used in the coextrusion process, i.e. the permanent union of two materials with different degrees of Shore hardness. RESINFLEX Plasticized thermoplastic synthetic resin: Made from primary resin, its polyvinyl chloride composition provides high resistance and compatibility with Resinil in the COEXTRUSION process we use in most expansion joints. Thanks to the nature of the plasticizers used, the material maintains its essential elasticity characteristics over time.

APPLICATION 1. Choose the H-size profile corresponding to the thickness of the tile to be laid, taking care to ensure that the profile does not exceed the edge of the floor but is positioned 0.5 to 1 mm lower. 2. Spread the adhesive in the profile application area with the help of a notched trowel; 3. Cut the profile to the required length and place it so that the base sinks into the adhesive, pressing and aligning it; 4. Apply an additional layer of adhesive to the perforation and in the cavities of the vertical section of the profile in contact with the edge of the floor; 5. Generally leave...