profilit.ec positive profile COFLEX CD mortar bed movement joints in co-extruded synthetic resin are conceived to subdivide large tile bays. Extension clips may be vertically interlocked to match high thicker mortar beds. Exclusively suitable for pedestrian traffic, this profile provides limited protection to the tile edges and compensates slight differential movement due to substrate contraction and expansion. They are installed with thin-set mortar. Ideally used in retail shops, hotels, sports facilities and schools. Suggested floor bays: 172-7/32''ft2 (16m2). Coextruded Synthetic Resinil + Resinflex B = 8 mm RESINIL Thermoplastic synthetic resin for COEXTRUSION: Made from primary resin whose composition based on Polyvinyl Chloride characterizes it for high resistance and optimized compatibility with regards to long-lasting adhesion with plasticized resins used in the coextrusion process, i.e. the permanent union of two materials with different degrees of Shore hardness. RESINFLEX Plasticized thermoplastic synthetic resin: Made from primary resin, its polyvinyl chloride composition provides high resistance and compatibility with Resinil in the COEXTRUSION process we use in most expansion joints. Thanks to the nature of the plasticizers used, the material maintains its essential elasticity characteristics over time.

APPLICATION 1. Cut the profile to the required length; 2. Make sure that the groove or gap to be filled is the right size for the profile to fit into. 3. In general, for wooden floors calculate 0.5 mm less than the joint, for stone and ceramic floors the measurement is that of the joint; 4. Apply the adhesive (FIXXTEC) in the groove; 5. Position the profile by inserting it with uniform pressure and using a rubber mallet; 6. Remove any glue residue from the profile immediately; 7. Assemble the subsequent elements until the desired height is reached. CLEANING AND MAINTENANCE SYNTHETIC RESIN: Thermoplastic...