THERMAL SOLUTIONS OVERVIEW Spacetherm® PP (plasterboard / plywood) is a high performance reinforced laminate specifically designed to be directly fixed to existing solid walls. Spacetherm® aerogel insulation blanket is bonded to a plasterboard / plywood composite, for use in applications where low U-values are required with limited space. Spacetherm® PP lining boards can achieve similar performance to traditional plasterboard laminates, but at a fraction of the thickness, allowing specifiers greater flexibility and higher performance for refurbishment projects. Thin insulation system for hard to treat walls. The best thermal performance available. Minimum loss of room space. Direct fix to solid walls. Constant long term thermal performance 50 years+. Includes an integrated vapour control layer. Non-Hazardous material. Image showing Spacetherm® PP applied internally to a reveal on an existing external wall structure. INSTALLATION Spacetherm® PP can be directly fixed to existing walls either by using shot fired nails or by fixing to battens in the traditional manner. Fixings should be at no more than 500mm centres. Although drilling is not recommended it may be required for wiring and services. When drilling, care should be taken to compress the panel as much as possible to reduce insulation fibres wrapping around the drill bit. Image showing Spacetherm® PP components. Aerogel insulation bonded to Plywood which is bonded to Plasterboard. INTERNAL & EXTERNAL ANGLES Spacetherm® panels should be cut in such a way to allow for the jointing of the plasterboard and an unbroken run of insulation to the existing wall in both internal and external angles. Refer to Installation Guide for further details. PARTITION WALLS Where an internal partition abutts an external wall with Spacetherm® PP lining, ideally Spacetherm® PP should be returned onto the partition or alternatively stopped at the junction. Spacetherm® PP External angle detail www.proctorgroup.com The Haugh, Blairgowrie, Perthshire, PH10 7ER Tel: 01250 872 261 Fax: 01250 872 727 email: [email protected]

THERMAL SOLUTIONS REVEALS Spacetherm® WRB (window reveal board) is a high performance laminate specifically designed to be fixed or glued to the existing solid wall. Spacetherm® WRB consists of Spacetherm® aerogel insulation blanket bonded to plasterboard or fermacell with or without plywood reinforcement. For use in applications where low U-values are required with limited space. Any reveals such as those which may occur at windows, doors etc, should be treated in the same manner as the internal and external angles mentioned above. Refer to Installation Guide for further details. FLOOR & CEILING...