INSTALLATION 1. After you have removed the Bin from the carton, inspect the unit for signs of damage. If there is damage to the unit: Notify carrier within 24 hours after delivery. Save carton and packing materials for inspection purposes. Contact the Prince Castle Customer Sales Department at 1-630-462-8800 to arrange for a replacement to be sent. 1. Place the bin on a counter and seal its base to the counter with food-approved sealant. 2. Insert the power cord into a proper voltage receptacle. Note: This should be a dedicated outlet. No other equipment should be operating on this line (i.e....

1. Press the UP or DOWN arrow button until the heater to be changed is selected. For Top Cavity, the LED next to the UPR SHELF is on, and for lower cavity, the LED next to the LWR SHELF is on. After selecting the cavity, the left most character in the temperature display shows the heater. U is the Upper heater and L is the Lower heater. 2. To change the temperature of the selected zone, press and hold the SET POINT button and press the PRINCE CASTLE button for 6 seconds. The LED indicator next to PROG will light to indicate the Program Mode is active. 3. Use the UP and DOWN arrow buttons to increase...

Problem Cause Solution A. Display flashes Open relay. Replace Power Circuit Board “Opn” & “rEL” Circuit inoperable B. Display flashes Shorted relay. Replace Power Circuit Board. “SHr” & “rEL” Circuit inoperable. Open heater. Test heater resistance.(150.2 Ohms) C. Display shows “LLL” Temperature is below 75° F Normal display during warm up. Heater inoperable. Test heater resistance.(150.2 Ohms) Probe inoperable. Check for open thermocouple wires from Relay Inoperable probe. Replace heater/probe assembly. D.Display shows “HHH” for Temperature is above300° F Diagnostic circuit inoperable. Replace...