Product Data Sheet Technical Data Vehicle: Finish: Universal HP Alkyd Metal Primer Phenolic Alkyd Light Gray Flash Point: S4700 Weight Solids: Universal HP Alkyd Metal Primer is a fast drying, high performance, high solids, rust inhibitive, alkyd metal primer designed for use over iron and steel substrates. Can be used as a “universal” primer under high performance topcoats and is also suitable as a “barrier” coat over conventional coatings which would normally be attacked by strong solvents in high performance coatings. • • • • • • • • • High build to protect sandblasted steel Rust inhibitive Good corrosion protection “Universal” primer under high performance topcoats “Barrier” coat over conventional coatings May be topcoated with alkyd, acrylic, and high performance coatings Premium shop coat primer Fast dry time Interior and exterior use Recommended Uses Use this product on properly prepared interior and exterior surfaces of steel and iron, including structural steel, tanks, machinery and equipment, piping, and pipe racks. Weight/Gallon: 13.7 lb/gal VOC (less exempt solvents): VOC: 314 g/L - 2.62lb/gal as per 40 CFR 59.406 Recommended Film Thickness: 3.0 – 8.0 mils wet 2.0 – 5.0 mils dry Spread Rate: Apply by airless spray, brush or roller Drying Time (@ 4.0 mils wet, @50% RH): Note: Drying times are temperature, humidity and film thickness dependant. 40°F 77°F 120°F To Touch: 1 hour 30 min 10 min To Handle: 3 hours 1 hour 15 min To Recoat: Alkyds: 6 hours 2 hours 1 hour Urethanes: 24 hours 24 hours 6 hours Acrylics: 48 hours 24 hours 6 hours To Cure: 5 days 2 days 1 day Recommended Systems Reduction: Steel, Alkyd Topcoat ® 1 coat Pratt & Lambert Universal HP Alkyd Metal Primer ® 1-2 coats Pratt & Lambert Industrial Alkyd Enamel HS Steel, Aluminum Finish ® 1 coat Pratt & Lambert Universal HP Alkyd Metal Primer ® 1-2 coats Pratt & Lambert Aluminum Paint Shelf Life: Mixing: Mix paint thoroughly to a uniform consistency with low speed power agitation prior to use Steel, Epoxy Topcoat ® 1 coat Pratt & Lambert Universal HP Alkyd Metal Primer ® 1-2 coats Pratt & Lambert Acrylic Pre-Cat Epoxy ® or Pratt & Lambert High Build Mastic Epoxy ® or Pratt & Lambert Palgard Polyamide Epoxy ® or Pratt & Lambert Acrylic Waterborne Epoxy FOR INDUSTRIAL USE ONLY As of 4/29/13, complies with: OTC EC SCAQMD CARB LADCO Steel, Acrylic Topcoat ® 1 coat Pratt & Lambert Universal HP Alkyd Metal Primer ® 1-2 coats Pratt & Lambert Acrylic Waterborne DTM Coating Steel, Urethane Topcoat ® 1 coat Pratt & Lambert Universal HP Alkyd Metal Primer ® 1-2 coats Pratt & Lambert Acrylic Urethane Gloss 4/13

Product Data Sheet Surface Preparation WARNING! Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup. For more information, call the National Lead Information Center at 1-800-424-LEAD (in US) or contact your local health authority....