C RYSTA L L I N E WATE R P R O O F I N G R A P I D S ET WATE R P L U G DESCRIPTION PENEPLUG® is a rapid setting, integral crystalline cementitious waterstop designed to stop active water leaks and moisture ingress. RECOMMENDED FOR PENEPLUG® can be used internally or externally as a waterproof plugging mortar or where rapid setting and early strength gain is required. PENEPLUG® can be used on the following substrates: Plugging/stopping active water leaks Sealing of leaking joints, form tie holes or cracks Concrete Masonry Earthenware Stone Stops water ow Sets in approximately 30 seconds after mixing Durable Can be used underwater Can be mixed with water or used dry Easy to apply Packaged in easy to use, re-sealable containers Zero VOC - PENETRON powdered products contain zero volatile organic compounds and are safe for use both outdoors and in confined indoor spaces DIRECTIONS FOR USE Surface Preparation: The substrate must be clean, sound and free of any surface contamination, such as oils, coatings, paints, dirt, etc. Leaking areas must be cut back to sound material, leaving an appropriate chase for receiving PENEPLUG®. Mixing: Setting time is dependent largely on the amount of mixing water used. Standard mixing ratio at 68°F (20°C) is 2.5 lb (1.1 kg) PENEPLUG® and approximately 1 cup (0.25 l) of water. Water must be added to PENEPLUG® and mixed quickly. The mix should have a dry pack (dry earth) consistency, holding a shape when squeezed in your hand but easily crumbled when pressed with ngers. Mixing time is about 15 seconds with setting occurring about 30 seconds later. In cold weather, use lukewarm water. In higher temperatures, use cold water.

C RYSTA L L I N E WATE R P R O O F I N G R A P I D S ET WATE R P L U G Application: To avoid waste, only small quantities of PENEPLUG® should be mixed. After mixing, apply PENEPLUG® to the appropriate area immediately. Material should be formed into a wedge and forced into the leak. This can be accomplished with the use of a block of wood and hammer. Work the plug well into the area and then, applying as much pressure as possible, hold rmly in place for about 30 seconds or until set. After the leak has stopped, prime the area with a bond coat of PENETRON® and then ll the remaining void to the...