Photovoltaic module HIT HIT-N245 HIT-N240
2Pages

Photovoltaic module HIT® HIT-N245 HIT-N240 Water drainage frame - Rain water is drained off the module surface. - This avoids not only water accumulation, but also water stains after drying. - Even in low-angle installations, water drainage corners keep the module clean. Power from both sides - HIT® generates solar electricity simultaneously on the front and on the back side. - This additional amount of light from the back side is combined with the light taken up by the front side of the module. Vertically integrated factory - Efficient production flow improves product quality as entire process from wafer to cell is done at the same location. - No risk of damage of individual components during transportation between factories. * For N245 Technology of HIT® Our HIT® is made of a thin monocrystalline silicon wafer surrounded by ultra-thin amorphous silicon layers. This product offers the industry's leading performance and value, using state-of-the-art manufacturing techniques. The development of the HIT® was supported in part by the New Energy and Industrial Technology Development Organization (NEDO). Cell structure of HIT® Clean surface with minimal loss Ultra-thin amorphous silicon layers Benefit in Terms of Performance Special features Our solar modules are 100% emission free, have no moving parts and produce no noise. The dimensions of the modules enable a space saving installation and the achievement of maximum output power possible on a given roof area. High performance at high temperatures With its very low temperature coefficient of only -0.29%/°C, our solar cell can maintain a higher efficiency than a con- ventional crystalline silicon solar cell, even at high temperatures. Yield comparison 120 normalized output power (kWh/kWp) Panasonic is truly committed to quality since it began developing and manufacturing solar PV technology in 1975. Our long track record is supported by our claim-rate of only 0.0038% among all modules sold in Europe (as of August 2014). Nagano (Japan), 2012, facing west-south-west, tilt angle 20° J cummulative yield Cell efficiency Module efficiency “HIT” is a registered trademark of Panasonic Group. Panasonic Eco Solutions Europe Panasonic Electric Works Europe AG

Electrical and Mechanical Characteristics N245, N240 (at STC) Open circuit voltage (Voc) [V] Short circuit current (Isc) [A] Max. over current rating [A] Production tolerance power [%] Temperature characteristics Temperature (NOCT) [°C] Temp. coefficient of Voc [V/°C] Temp. coefficient of lsc [mA/°C] At NOCT (Normal Operating Conditions) Max. power (Pmax) [W] Open circuit voltage (Voc) [V] Short circuit current (Isc) [A] back side weight: 15 kg weight/m²:11,9 kg/m² unit: mm front side Temp. coefficient of Pmax [%/°C] Note: Standard Test Conditions: Air mass 1.5; Irradiance = 1000W/m2; cell...