POLYX®-OIL TINTS
2Pages

PRODUCT INFORMATION | INTERIOR POLYX®-OIL TINTS The renowned Polyx®-Oil in a coloured variation! PRODUCT DESCRIPTION Transparent, satin wood finish that uniquely combines the advantages of natural oils and waxes in one product. Osmo Polyx®-Oil Tints is stain-resistant, waterrepellent and abrasion-resistant and results in a surface that is pleasant to the touch. In comparison to conventional finishes, the use of plant ingredients creates a more even colour and more harmonious appearance. Simple application – without primer or intermediate sanding – this saves time and money. Suitable for wood; microporous surface will not crack, peel, flake or blister. Resistant against wine, beer, cola, coffee, tea, fruit juice, milk and water in accordance with German DIN 68861-1A – no water spots. The dry finish is safe for humans, animals and plants (resistant to saliva and perspiration acc. German DIN 53160, suitable for children‘s toys acc. EN 71.3). RECOMMENDED USE Osmo Polyx®-Oil Tints is ideal for the protection and decorative finishing of all wooden floors, such as solid wood, plank, strip, OSB and cork flooring, as well as furniture surfaces. It is only recommended for lightly coloured wood species. INGREDIENTS Based on natural plant oils and waxes (sunflower oil, soya oil, thistle oil, carnauba wax and candelilla wax), paraffin, iron oxide and organic pigments, titanium dioxide white pigment, siccatives (drying agents) and water-repellent additives. Dearomatized white spirit (benzene-free). EU limit value for this product (cat. A/i): 500 g/l VOC (2010). This product contains max. 500 g/l VOC. Detailed declaration of ingredients available upon request. TECHNICAL DATA Specific gravity: 0.90-0.95 g/cm³ Viscosity: 30-45s DIN EN ISO 2431/4 mm, thixotropic Odour: faint/mild, after drying odourless Flash point: >60°C acc. DIN EN ISO 2719 STORAGE Up to 5 years and longer if can is kept dry and closed tightly. If thickened by frost, store for 24-36 hours at room temperature before use. SURFACE PREPARATION Wood surface must be clean, dry and frost-free (moisture content max. 18%). Osmo Polyx®-Oil Tints is ready to use. Do not thin. Stir well before use. Clean old microporous stains thoroughly. Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works. Fill small cracks, larger joints or holes in wood (Osmo Wood Filler). Sand wood surfaces carefully. Begin with coarse sandpaper – final sanding work for flooring P120-150, for furniture P180-240. Before oiling the surface, remove sanding dust with a broom or vacuum. The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces. Page 1 - POLYX®-OIL TINTS Osmo Holz und Color GmbH & Co. KG · Affhüppen Esch 12 · D-48231 Warendorf Phone +49 (0)2581/922-100 · Fax +49 (0)2581/922-200 · info@

PRODUCT INFORMATION INTERIOR METHODS OF APPLICATION Transparent colour: With Osmo Flat Brush, Microfibre Roller, Oil Finish Applicator Fleece (Hand Pad Holder) or Floor Brush, apply thinly and evenly to the clean and dry wood along the wood grain and spread well. Allow to dry for approx. 24 hours under good ventilation. If a stronger colour intensity is desired, repeat the process (however maximal two coats). Lightly stained effect: Within 20 minutes after application, wipe away product along the wood grain with a cloth or white pad. Allow to dry for approx. 24 hours under good ventilation....