Orencos Universal Flow Inducer houses any Orenco high-head effluent pump in applications where filtration is not necessary. The base rests on the bottom of the tank, and the mounting flange is epoxied to a PVC riser. The flow inducer can be lengthened or shortened to fit any tank. The tee, which holds the mounting flange and float assembly bracket, slides to any position along the flow inducer. A float assem- bly (ordered separately) snaps into the bracket. Applications include:ҕ Pump tanks Disinfection systems Օ Effluent reuse systems Cisterns To specify this product, require the following:Օ Class 125 4-in. (nominal) PVC pipe body Injection-molded ABS mounting flange Օ Injection-molded holster for float tree Ability to accommodate flows as great as 65 gpm (4.1 L/sec) > Approximate Dimensions > Flow inducer diameter 4 in. nominalHeight 72 in. (1828 mm) (can be lengthened or shortened)Shipping weight 13 lb (5.9 kg) Materials of Construction > Flow inducer Class 125 PVC Mounting flange Injection-molded ABS Base Fiberglass-reinforced polyester Mounting bracket epoxied to PVC riser Sliding teeMounting flange (fits 3-in. pipe)4-in. flow inducerFloat assembly (ordered separately)Float assembly bracket 1 3/8-in. (35-mm) inlet holes High-head pump Discharge assemblyFloat assembly > Typical installation in concrete pump tank. Use screws to secure mounting bracket to riser while epoxy cures. Fiberglass base > NTD-UFI-1Rev. 1.0, 3/08թ Orenco Systems , Inc. size="-2">