Above and left, s96w asymmetric bench, L1.8m, root fixed. description Galvanized steel cantilever support beam with offset seat supports. Iroko seat boards. 1800/2400 dimensions Length 1800/2400, depth 455mm, height 445mm. options Bench with offset legs (asymmetric). Available as above surface flange, below surface flange fixed or root fixed. Unfinished timber or micro porous wood stain. Ground level street furniture designers and manufacturers

s96w AGFF Fixing Instructions (for areas already paved) 1 Determine the location for the bench. Remove the pavers and excavate two holes at centres 1725 or 2325mm (depending on size version) to minimum dimensions of L600 x W600 x D400mm. The size of the foundations may vary depending on the ground conditions. Foundations must be to Engineer’s specification. 2 Fill the holes with 35N20 concrete up to 15mm below the level of the underside of the pavers ensuring a good smooth surface finish. 3 Allow sufficient time for the concrete to set then apply a layer of dry sand/cement mix over the pad. Compact...

s96w BGFF Fixing Instructions (for areas already paved) 1 Determine the location for the bench. Remove the pavers and excavate two holes at centres 1725 or 2325mm (depending on size version) to minimum dimensions of L600 x W600 x D400mm. The size of the foundations may vary depending on the ground conditions. Foundations must be to Engineer’s specification. 2 Fill the holes with 35N20 concrete up to 135mm below the level of the underside of the pavers ensuring the pads are level relative to each other (if the paving is not level then aim to achieve an average of 135mm). The pads should be floated...

s96w RF Fixing Instructions (for areas already paved) 1 Determine the location for the bench. Remove the pavers and excavate two holes at centres 1725mm or 2325mm (depending on size version) to minimum dimensions of L400 x W400 x D550mm. The size of the foundations may vary depending on the ground conditions. Foundations must be to Engineer’s specification. 2 Place the bench into the holes and position at the correct height above ground level. Ensure the bench is level then prop securely. 3 Back fill holes with concrete (35N20) leaving sufficient depth for paving slabs and bedding. 4 Once set...

s96w Care and Maintenance Guidelines The s96w bench is constructed from painted galvanized steel and iroko hardwood. The materials have been selected for their excellent outdoor durability as well as their aesthetic properties. The timber components have had a micro porous woodstain factory applied as a means of preserving the rich colour of the timber and maximising longevity. Some care is required to maintain the product’s original appearance. The extent to which maintenance is required will depend on a number of factors including environmental conditions, construction activity and level of...

Wood Finishes Below shows Iroko timber with factory applied micro-porous stain. This finish offers very good resistance to UV rays and provided the coating surface does not become broken the colour will not fade for several years. The coating is however vulnerable to conditions where high moisture and severe cold persist. Such conditions can cause the coating to blister and lift. Where maintenance is required the surface can be re-coated using a brush on version of the coating. Omos provide maintenance instructions for all products. Below shows Iroko timber untreated and freshly sanded. The inset...