Above, s56 with honed light grey granite, oiled finish to wood and anti-skate dividers. description Cut stone ends and galvanized steel frame with provision for under seat lighting. Treated hardwood surface with or without ‘anti-skate’ bars. dimensions Length 2000mm, width 615mm, height 455mm. options Unfinished timber or micro porous stain. With or without anti-skate bars. street furniture designers and manufacturers

s56 Fixing Instructions (for areas already paved) 1 Determine the location for the bench. Remove the pavers and excavate two holes at centres 1750mm to minimum dimensions of L600 x W600 x D400mm. The size of the foundations may vary depending on the ground conditions. 2 Fill the holes with 35N20 concrete up to 15mm below the level of the underside of the pavers ensuring a good smooth surface finish. 3 Allow sufficient time for the concrete to set and then apply a layer of dry sand/cement mix over the pad. Compact and adjust this to the level of the underside of the paving. 4 Replace the paving...

s56 Care and Maintenance Guidelines The s56 bench is constructed from granite, galvanized mild steel and iroko hardwood (stainless steel anti-skate bars optional). The materials have been selected for their excellent outdoor durability as well as their aesthetic properties. The timber components have had a micro porous woodstain factory applied as a means of preserving the rich colour of the timber and maximising longevity. Some care is required to maintain the product’s original appearance. The extent to which maintenance is required will depend on a number of factors including environmental...

Wood Finishes Below shows Iroko timber with factory applied micro-porous stain. This finish offers very good resistance to UV rays and provided the coating surface does not become broken the colour will not fade for several years. The coating is however vulnerable to conditions where high moisture and severe cold persist. Such conditions can cause the coating to blister and lift. Where maintenance is required the surface can be re-coated using a brush on version of the coating. Omos provide maintenance instructions for all products. Below shows Iroko timber untreated and freshly sanded. The inset...

Each of the pieces shown above are Granite ref. G603, also referred to as Light Grey. The finishes are as follows: 1 Polished A polished finish gives the stone reflective properties. When viewed straight on, with no reflections, it appears slightly darker than the other finishes. 2 Flamed A flamed finish has a lightly textured surface. As the name suggests it is achieved by passing a flame across the surface causing the surface to flake leaving a random textured finish. 3 Bush Hammered Like the flamed finish a bush hammered finish is also textured though it is courser. The finish is achieved...