s19ms bench
1 / 4Pages

Catalog excerpts

s19ms bench - 1

Above, s19ms in painted mild steel with oiled finish to wood. description Powder coated galvanized mild steel frame with extended tubes for root fixing. Seat surface in iroko hardwood. dimensions Length 1800mm, width 617mm, height 500mm. options Unfinished timber or micro porous stain. street furniture designers and manufacturers

Open the catalog to page 1
s19ms bench - 2

s19ms Fixing Instructions (for areas already paved) 1 Determine the location for the bench. Remove the pavers and excavate two holes at centres 1500mm to minimum dimensions of L400 x W400 x D550mm. The size of the foundations may vary depending on the ground conditions. 2 Place the bench into the holes and position the bench in the holes at the correct height above ground level. Ensure the bench is level and then prop securely. 3 Back fill holes with concrete (35N20) leaving sufficient depth for paving slabs and bedding. 4 Once set remove props. 5 Where necessary cut the paving slabs and...

Open the catalog to page 2
s19ms bench - 3

s19ms Care and Maintenance Guidelines The s19ms bench is constructed from painted galvanized mild steel and iroko hardwood. The materials have been selected for their excellent outdoor durability as well as their aesthetic properties. The timber components have had a micro porous woodstain factory applied as a means of preserving the rich colour of the timber and maximising longevity. Some care is required to maintain the product’s original appearance. The extent to which maintenance is required will depend on a number of factors including environmental conditions, construction activity and...

Open the catalog to page 3
s19ms bench - 4

Wood Finishes Below shows Iroko timber with factory applied micro-porous stain. This finish offers very good resistance to UV rays and provided the coating surface does not become broken the colour will not fade for several years. The coating is however vulnerable to conditions where high moisture and severe cold persist. Such conditions can cause the coating to blister and lift. Where maintenance is required the surface can be re-coated using a brush on version of the coating. Omos provide maintenance instructions for all products. Below shows Iroko timber untreated and freshly sanded. The...

Open the catalog to page 4

All Omos Ltd. catalogs and technical brochures

  1. t3 seat

    3 Pages

  2. s83 bench

    5 Pages

  3. s66 bench

    4 Pages

  4. s64 bench

    4 Pages

  5. s56 bench

    5 Pages

  6. s30.2 bench

    6 Pages

  7. s22 bench

    3 Pages

  8. s06 bench

    3 Pages