Catalogs >
Oakworks >
Treatment Table

Treatment Table
4Pages

Catalog excerpts

PowerLine™ & Seychelle™ TREATMENT TABLE ASSEMBLY & OPERATION INSTRUCTIONS Seychelle™ with Flat Top and Shelf Seychelle™ with Backrest Top and Shelf PowerLine™ with Flat Top PowerLine™ with Backrest Top PowerLine™ with Flat Top and Shelf PowerLine™ with Backrest Top and Shelf

Open the catalog to page 1

Treatment Table H-Brace and Shelf SUPPLIED PARTS: LEG HARDWARE TOOLS 1 - Large Allen Wrench 1 - Small Allen Wrench 1 - Open End Wrench STRETCHER BEAM 8 -Flat Washers 4 -Disc Washers (dull finish) 4 - Long Large Bolts 4 - Lock Nuts 1 - Wood Stretcher Beam 2 - Short Bolts 2 - Barrel Nuts SHELF (OPTIONAL) 8 - Velcro® Strips for Shelf Stretcher Beam Removable Shelf Assembly Instructions 1. Remove the table from the box and place it down on the floor with the top down. Remove all hardware and the stretcher beam. 2. Unfold the legs to a vertical position and remove any protective wrappings. (Fig....

Open the catalog to page 2

PAPER ROLL HOLDER INSTALLATION The Paper Roll Holder comes standard with PowerLine™ Treatment Tables. paper roll holder bracket (2) Supplied Parts screws (2) wooden dowel (1) notch After the table is set-up, locate the hole in the leg. rounded edge Locate one paper roll holder bracket. Be sure the notch is at the top & rounded edge away from the table. Using the supplied screw & allen wrench, secure the paper roll holder bracket into place. Repeat steps 1 thru 3 on the other side. notch Locate the wooden dowel & feed it thru your paper roll. Place the notch on the wooden dowel in the hole...

Open the catalog to page 3

Treatment Table Optional Accessories & Table Care Attaching the Table Extender: 1. The table is equipped with two outlet holes at either end to allow the use of a Table Extender. Unfold the aluminum dowels of the extender and insert them into the outlet holes at either end of the table. (Fig. 8 & Fig. 9) CAUTION: DO NOT sit, lean or use the Extender or Paper Roll Holder in mounting or dismounting from the table. Fig. 8 Attaching & Using the QuickLock™ Face Rest: 1. Insert the ends of the Face Rest frame into the outlet holes at either end of the table. (Fig. 10) 2. Starting with the face...

Open the catalog to page 4