video corpo

Clodagh Libra
24Pages

{{requestButtons}}

Catalog excerpts

Clodagh Libra - 1

Libra INSTRUCTION www.oakworks.com · 717.235.6807 MANUAL ™

Open the catalog to page 1
Clodagh Libra - 2

© Copyright 2010 OAKWORKS® , Inc. Manual Part # MMMNST0020 1st Edition, May 2010 Printed in U.S.A. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language without prior written consent of OAKWORKS®, Inc. OAKWORKS® is a registered trademark of OAKWORKS®, Inc. Notice The information contained in this document is subject to change without notice and should not be construed as a commitment by Oakworks®, Inc. Oakworks®, Inc. assumes no responsibility for any errors that may appear in this document nor does it make expressed or implied...

Open the catalog to page 2
Clodagh Libra - 4

SYMBOL IDENTIFICATION SYMBOL IDENTIFICATION SYMBOL IDENTIFICATION This symbol, when used in this manual and on product labels, represents a caution. Be sure to read and comply with all precautions and warnings. This symbol, when used in documentation on this product, indicates danger and warns against an electrical shock hazard. Be sure to observe and comply with all warnings and instructions. This symbol, when used in documentation on this product, indicates a Protective Earth (Ground) Terminal. This symbol when used in documentation on this product, warns that during transport there...

Open the catalog to page 4
Clodagh Libra - 5

READ AND SAVE THESE INSTRUCTIONS WARNINGS / SAFETY WARNINGS & SAFETY INSTRUCTIONS IMPORTANT WARNINGS & SAFETY INSTRUCTIONS Improper use of this device can cause injury. Be sure to read all operating instructions prior to use to prevent injury to operator or client. DANGER Electrical Shock Hazard. • To reduce the risk of electric shock, always disconnect the table from the electrical outlet before moving the table or doing any maintenance or troubleshooting procedures. Never use this equipment if it has a damaged cord or plug. Use this equipment only for its intended use as described in...

Open the catalog to page 5
Clodagh Libra - 6

WARNINGS & SAFETY INSTRUCTIONS WARNINGS / SAFETY READ AND SAVE THESE INSTRUCTIONS WARNINGS CONTINUED IMPORTANT WARNINGS & SAFETY INSTRUCTIONS This product is equipped with an interior accessory outlet (110V only). The total electrical load plugged into this set of outlets is not to exceed 1000 watts. • Risk of Injury – Children should never be near the table when in use. Remove ON-Off key when not in use. (if applicable) • Never drop or insert any object into any opening. • Risk of accidental injury or drowning. Exercise care when entering or exiting the foot bath. Invalid or disabled...

Open the catalog to page 6
Clodagh Libra - 7

READ AND SAVE THESE INSTRUCTIONS CAUTIONS WARNINGS / SAFETY WARNINGS & SAFETY INSTRUCTIONS WARNINGS WARNINGS & SAFETY INSTRUCTIONS • Be certain that the table is completely lowered prior to discharging an ambulatory patient. The patient may lose balance and fall. Do not leave clients unattended when table is set at its highest level. • The table weighs as much as 225 lbs. (102 kg.) DO NOT lift or move the unit without using proper safely procedures or equipment. DO NOT turn the table on its side for any reason. To do so could cause damage to the base and will void the warranty. There are no...

Open the catalog to page 7
Clodagh Libra - 8

WARNINGS & SAFETY INSTRUCTIONS (CONTINUED) GROUNDING INSTRUCTIONS GROUNDING & FOOT BATH CERTIFICATION GROUNDING INSTRUCTIONS CAUTIONS GROUND FAULT & GROUNDING INSTRUCTIONS The integral GFCI should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, DO NOT USE THE UNIT. Disconnect the unit and have the problem corrected by a qualified service representative or an electrician before using. • This product must also be connected to a Ground Fault...

Open the catalog to page 8
Clodagh Libra - 9

PRODUCT DESCRIPTION PRODUCT DESCRIPTION PRODUCT DESCRIPTION Backrest top Manicure Arm rests (2) Powder Coated Steel Base PediBath Hydraulic Lift Columns (4) Storage shelf TABLE SPECIFICATIONS • Lift Capacity: 500 lbs. (226 kg.) • Weight: 200 lbs. (91 kg.) • Shipping Weight: 250 lbs. (114 kg.) • Shipping Box Dimensions: 81” L x 37” W x 31” H • Height Range: 25” - 33” (64-84 cm) • Width: 30” (76 cm) • Length: 77” (195 cm) • Top: Electronically Controlled Backrest Top • Base: Metal Frame Base with shelf and electric height adjustment • Electronics: 1 Hand Control & 1 Foot Control • Padding: 4”...

Open the catalog to page 9
Clodagh Libra - 10

INSTALLATION INSTALLATION INSTALLATION When operating the table’s controls be sure to observe all cautions and warnings given in the manual to prevent injury to both operator and client. ASSEMBLY & INSTALLATION INSTALLATION The table comes completely assembled and ready to use. Plug the cord into a functioning GFCI outlet that is rated for the table. Arrange the power cord and foot switch so that they will not create a tripping hazard. Place the controls in a safe location where they are convenient and accessible. Keep the controls out of the way of all table mechanisms. LEVELING...

Open the catalog to page 10
Clodagh Libra - 11

DIRECTIONS FOR USE CAUTION When operating the controls and making any and all adjustments to the table, move hands and feet away from the working mechanism of the table. ADJUSTING HEIGHT OF THE TABLE DIRECTIONS FOR USE DIRECTIONS FOR USE The table comes complete with a multi-functional hand control that operates the backrest and seat positioning functions as well as a foot control that operates the height with ease. Foot Control Operate the foot control as shown below to raise or lower the height of the table. When operating the table’s controls, be sure to observe all cautions and warnings...

Open the catalog to page 11
Clodagh Libra - 12

DIRECTIONS FOR USE DIRECTIONS FOR USE ADJUSTING THE TOP Hand Control - 4 Positioning Buttons When operating the table’s controls be sure to observe all cautions and warnings given in the manual to prevent injury to both operator and client. The hand control operates all the positioning of the backrest and seat. Press and hold the appropriate button until the position desired is achieved and then release. The arm rests will adjust automatically to provide the most in comfort and ergonomics while staying parallel to the floor, no matter what the position. 1 Back Rest Control: CAUTION DO NOT...

Open the catalog to page 12

All Oakworks catalogs and technical brochures

  1. Antigua

    28 Pages

  2. OAKWORKS

    32 Pages

  3. PORTAL LIGHT

    4 Pages

  4. libra

    2 Pages

  5. Masters

    15 Pages

  6. Spa Catalog

    44 Pages

  7. AURORA™

    32 Pages

  8. PROLUXE™

    32 Pages

  9. Symphony

    1 Pages

  10. EQUINOX

    1 Pages

  11. Trolley

    8 Pages

  12. Exam Tables

    20 Pages

  13. Powerline

    2 Pages

Archived catalogs

  1. Clodagh Leo

    20 Pages

  2. Advanta

    2 Pages