INSTRUCTION MANUAL Clodagh Gemin Clodagh Gemini with US & imported parts

© 2012 Oakworks® , Inc. • How to Care for Your Upholstery Symbol identification Notice All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language without prior written consent of Oakworks®, Inc. Oakworks® is a registered trademark of Oakworks®, Inc. The information contained in this document is subject to change without notice and should not be construed as a commitment by Oakworks®, Inc. Oakworks®, Inc. assumes no responsibility for any errors that may appear in this document nor does it make expressed or implied warranty of any kind with...

Symbol Identification Symbol identification Symbol identification Symbol Identification This symbol, when used in documentation on this product, represents a caution. Be sure to read and comply with all precautions and warnings. This symbol, when used in documentation on this product, indicates danger and warns against an electrical shock hazard. Be sure to observe and comply with all warnings and instructions. This symbol, when used in documentation on this product, indicates a Protective Earth (Ground) Terminal. R US C LISTED UL 2601-1 CSA C22.2 NO.601.1 IEC 60601-2 (2001-09) This symbol when...

warnings & Important Safety Instructions Important Safety Instructions warnings Read and Save These Instructions When using an electrical furnishing, basic precautions should always be followed, including the following: Improper use of this device can cause injury. Be sure to read all instructions prior to use to prevent injury to operator or client. WARNING To reduce the risk of burns, fire, electrical shock or injury: • Electrical Shock Hazard. To reduce the risk of electric shock, always disconnect the table from the electrical outlet before moving the table or doing any maintenance or troubleshooting...

symbol identification WArnings & important safety instructions Warnings Symbol Read and identification Save These Instructions Important Safety Instructions (cont.) This product is equipped with an interior accessory outlet. The total electrical load of equipment plugged into this set of outlets is not to exceed 840 watts. • Plug table into an outlet that is surge protected to a level of 750J or higher. Failure to do this may void all or part of the warranty. CAUTION • Close supervision is necessary when this furnishing is used by, or near, children, invalids or disabled persons. Do not leave...

Read and Save These Instructions WARNING Important Safety Instructions (cont.) Grounding instructions: This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electrical current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. This product is for use on a nominal 120-volt circuit (see below, USA plug example)and...

product description product description Symbol identification Celesta Model: CEMP Self Adjusting Removable Arm Rests (2) (option) Universal Table Extender (optional accessory) Fully Enclosed Cabinet Base Cabinet doors (access both sides) Accessory Outlets (2) Vertical Electronic Lift Columns (4) Foot Control (1) Tab l e S p e cs * : • Height *: 25” - 37” (64 cm - 94 cm) • Width: 29” (74 cm), 31” (79 cm) • Length: Flex top - 72” (183 cm) Flat top - 73” (185 cm) • Lift Capacity: 625 lbs (284 kg) Maximum Working Load Flat Top model shown here with QuickLock ™ Face Rest and Boiance ™ Crescent • Weight:...

Clodagh Gemini™ product description product description Model: CNCD Self Adjusting Removable Arm Rests (2) (option) Universal Table Extender (optional accessory) Cabinet doors (6 - access both sides) Accessory Outlets (2) Vertical Electronic Lift Columns (4) Foot Control (1) Fully Enclosed Cabinet Base Exterior Cabinet shelf; foot end only (1) Tab l e S p e cs * : • Height *: 25” - 37” (64 cm - 94 cm) • Width: 29” (74 cm), 31” (79 cm) • Length: Flex top - 72” (183 cm) Flat top - 73” (185 cm) • Lift Capacity: 625 lbs (284 kg) Maximum Working Load • Top: Electric Salon Top or Flat Top Flat Top...

symbol identification • How to Care for Your Upholstery installation Installation When operating the table controls be sure to observe all cautions nd warnings given a in the manual to prevent injury to both operator and client. The table comes completely assembled and ready to use. Plug the cord into a functioning outlet that is rated for the table. Arrange the power cord and control cords so that they will not create a tripping hazard. Place the controls in a safe location where they are convenient and accessible. Keep the controls out of the way of all table mechanisms. L ev eli ng I ns tru...

symbol identification directions for use caution Adjusting the height and top directions for use When operating the table’s controls be sure to observe all cautions and warnings given in the manual to prevent injury to both operator and client. The table comes complete with a multifunctional foot control that operates the backrest, leg rest, and height. These controls should not be used simultaneously but individually to ensure safety and complete ease of use. Press and hold the appropriate button until the position desired is achieved and then release. The arm rests will adjust automatically...

directions for use Directions for Use Symbol 8identification IMPORTANT caution Do not store or place anything on the cabinet hood under the backrest as this can cause damage to the top and/or hood. Important safety note The cabinet hood area under the backrest top is not designed for storage or as an area to hold accessories while with a client. DO NOT use this area for holding anything. Damage can occur to the table, especially when the pre-set position commands that are accessed by the hand control are activated. Placing anything on this area is prohibiting movement of the backrest and can...