ELECTRIC WATER HEATER Design EMINENT is available with three different types of corrosion resistant lining material in the water tank; copper, enamel or stainless steel. The type of anticorrosive lining used in the tank is determined by the type of water used in the tank. Copper – The water tank consists of a steel vessel, with a copper lining to protect against corrosion. Enamel The water tank consists of a steel vessel, with an enamel lining to protect against corrosion. The enamel lining is protected by a sacrificial anode which is located at the top of the vessel for easy access. Stainless steel – The water tank consists of a stainless steel vessel, (EN 1.4521) which is precision welded and then pickled in an acid bath to ensure a high-quality finish. The outer casing of EMINENT is made from powder coated sheet steel with impact resistant plastic top/bottom. The pressure vessel is designed and manufactured, in accordance with current pressure vessel standards (PED 97/23 EC § 3.3), for a maximum working pressure of 9 bar (0.9 MPa), which is the equivalent to a design pressure of 10 bar (1.0 MPa). The water tank’s seamless, flame-resistant, blow-moulded polyurethane foam insulation provides an excellent heat insulation. Installation Install the water heater by mounting it vertically with the connections downwards or horizontally on the adjustable attachment. Use the supplied mounting brackets for vertical installation. Screw the brackets into place first. Then mount the heater on the brackets. Water heaters for weekend cottages and houses A complete set of valves, consisting of a mixer valve, shut-off valve, non-return valve, safety valve and drain valve, are factory fitted. ENAMEL COPPER STAINLESS STEEL When mounting the heater, be sure to leave sufficient room for inspection of the electrical equipment, see the Dimensions section. When installing the EMINENT E, also ensure that there is enough room to allow for regular inspection of the sacrificial anode. Electrical equipment The water heater’s connecting cable is equipped with a plug for an earthed single-phase socket. The socket must be positioned for easy access. Single-phase installation (1 kW) offers the least surface load on the immersion heater and thus a longer life. A two-phase installation (3 kW) will give faster heating. The flanged, stainless steel (Alloy 254 SMO) immersion heater in a Ø 80 mm connection opening allows for simple dismantling and internal inspection of the vessel. Adjustable thermostatic control to 80 °C. The advantages of EMINENT effective, pro-environmental insulation quick and simple to install, vertically or horizontally best performance and safety

1 Connection cable 2 Cover, electrical connection box EMINENT 30 = 410 EMINENT 55 = 410 EMINENT 100 = 480 22 Shut-off and non-return valve 40 Sacrificial anode * 41 Cold water connection, compression ring coupling Ø 15 mm EMINENT 30 = 405 EMINENT 55 = 405 EMINENT 100 = 475 42 Hot water connection, compression ring coupling Ø 15 mm 43 Drain pipe connection from safety valve/draining EMINENT 30 = 70 EMINENT 55 = 70 EMINENT 100 = 80 23 Safety valve, drain valve EMINENT 30 = 475 EMINENT 55 = 745 EMINENT 100 = 980 compression ring coupling Ø 15 mm 44 Space for pipes 7 Fully isolated circuit-breaker...