TECHNICAL SPECIFICATION Short FRONT ELEVATION SIDE ELEVATION Distance from the aerator to the end of the tap Water entry point Rear cable entry point Fixing locations (4) All dimensions shown in inches (+/- 3/16") FLOOR Minimum clearance Z 4" (100mm) clearance from floor. ADA requires 9 " (228mm) toe clearance.

TECHNICAL SPECIFICATION Tall SIDE ELEVATION Distance from the aerator to the end of the tap Water entry point Rear cable entry point Fixing locations (4) All dimensions shown in inches (+/- 3/16") Minimum clearance Z 4" (100mm) clearance from floor. ADA requires 9 " (228mm) toe clearance.

TECHNICAL SPECIFICATION Wall SIDE ELEVATION FRONT ELEVATION Water entry point 10 1⁄4" (260mm) FLOOR Minimum clearance Suggested installation height 37 9/16" (955mm) from finished floor to center of tap, depending on height of sink. Check installation guide for further details. Cable entry point 2 1⁄16" (52.2 from Distance mm) the aerator to the end of the tap

TECHNICAL SPECIFICATION Wall WD06 Wall installation The Dyson Airblade Wash+Dry hand dryer is designed so that the motor unit is located behind the stud wall within a metal enclosure which is supplied with the Dyson Airblade Wash+Dry hand dryer (Fig.1). The vertical wall studs must be constructed so as to allow the metal enclosure to be fitted between them (Fig.2). One of the horizontal wall studs must be fitted a) so it holds the main weight of the metal duct and the unit, and b) so it is in the correct position for the tap stem. For complete instructions, please refer to the printed installation...

TECHNICAL SPECIFICATION Electrical Sink specification Input voltage: Low Voltage = 100-110V, High Voltage = 200-240V The Dyson Airblade Wash+Dry hand dryer is compatible with most sink types. Ensure plugs are not installed in the sinks and avoid inserts with embedded plugs (e.g. ones that swivel or elevate). Frequency: Low Voltage = 50-60Hz, subject to voltage (120V at 60Hz; 100-110V at 50Hz), High Voltage = 50-60Hz Motor specification: 1000W digital brushless motor Motor Speed: 81,000 rpm Motor Switching rate: 5,400 per second Motor type: Dyson digital motor – V4 brushless DC Motor Amp: Recommended...

Further documents are available online to download: Pre-installation guide Installation guide Dyson Airblade Wash+Dry hand dryer brochure Cleaning guide CAD drawings Installation videos The Carbon label is a trademark of the Carbon Trust. HACCP International non-food certification mark is the registered trademark of HACCP International. HACCP International have certified Dyson products based on their recommended installation and operating conditions. Licensed by Dyson. Quiet Mark is a trademark of the Noise Abatement Society. For further information, please contact Dyson: 1-888-397-6622 | [email protected]...