PROFORM® BRAND TINTED-LITE JOINT COMPOUND National Gypsum Company Technical Information: Internet Home Page: ProForm® BRAND Tinted-Lite Joint Compound is a vinyl base ready mix lightweight joint compound. Approximately 30% lighter than conventional ready mix, Tinted-Lite Joint Compound pulls and sands easier, pocks less and reduces BASIC USES in finishing gypsum board joints, spotting fasteners and finishing cornerbead. • Lightweight. Approximately 30% lighter than conventional ProForm Joint Compound. 33% less shrinkage than con- ventional joint compound. • Superior finish. Provides a finish with less pocking and • Easier pull. Spreads easier for quick application. • Finishes metal beads with two • Excellent sanding character- • Ready to use right from con- tainer after mixing. • Low VOC content - less than 2 GREENGUARD CERTIFIED ProForm Tinted-Lite Joint Indoor Air Quality Certified® "q"ali,y VJREENGUARD- Indoor Air Quality Certified • Use nothing coarser than a 150 grit sandpaper or a 220 grit abrasive mesh cloth for any • Protect from freezing and exposure to extreme heat and direct sunlight, conditions which will cause premature • Excessive mixing with an electric drill can cause viscosity and in finished surface Storage life varies with climatic under good conditions. Store compound away from extreme cold or heat to avoid accelerated aging. Regularly check production dates and rotate inventory on a first-in, first-out plan. SSIt^l Professional Formula If Tinted-Lite Joint Compound freezes, allow material to thaw at room temperature for at least 24 hours. When thawed, turn the container 15 minutes. Turn pail right immediately remix with an electric drill. Tinted-Lite ready to use within 1 minute. Discard all joint compound that does not remix to a lumpfree consistency. Tinted-Lite pails should not be stacked more than two • ProForm Joint Tape • Cornerbead, trims, casing • Multi-Flex Tape • E-Z Strip control joints or .093 zinc control joints ProForm® is a registered trademark of National Gypsum Properties, LLC.

TECHNICAL DATA PACKAGING & COVERAGE 4.5 gallon (17 L) Carton or Pail 8-8.2 Gal (32.6-33.4 L) 550-563 (51-52) ^Coverage varies with number of cornerbeads and trims used. APPLICABLE STANDARDS AND REFERENCES National Gypsum Company, Gypsum Construction Guide Pro Form BRAND, Drywall Finishing Products Construction Guide APPROXIMATE DRYING TIMES Note: R.H. = Relative Humidity D = Days (24 hour period) H = Hours The chart above is a helpful guide in determining approximate drying times for joint compounds under a variety of humidity/temperature conditions. Shaded area is below the minimum application...