PROFORM® BRAND TAPING READY MIX JOINT COMPOUND National Gypsum Company Technical Information: Internet Home Page: ProForm® BRAND Taping Ready mixed vinyl base compound that may be used directly BASIC USES Taping Joint Compound is de- signed to enhance bond when embedding joint tape or when accessories. Taping compound is also an excellent product to enhance bond when laminat- • Ready to use right from the • Excellent adhesion/bond. • Great for use in taping tools. • Low VOC content - less than GREENGUARD CERTIFIED ProForm Taping Ready Mix Joint Indoor Air Quality Certified Storage life varies with climatic under good conditions. Store compound away from extreme cold or heat to avoid premature aging. Regularly check production dates and rotate inventory on a first-in, first-out plan. If Taping Joint Compound freezes, allow material to thaw at room temperature for at least 24 hours. When thawed, turn container minutes. Turn pail right side ately remix with an electric drill. Taping Joint Compound minute. Discard all Taping Joint Compound that does • ProForm Joint Tape • Cornerbead, trims, casing • Multi-Flex Tape • E-Z Strip control joints or .093 zinc control joints Sessional Formula WHJoint Compound TECHNICAL DATA PACKAGING & COVERAGE ^Coverage varies with number of cornerbeads and trims used. Taing Compound is available in Central, Midwest and Western areas (Continued next page) Submittal Approvals: (Stamps or Signatures) • Protect from freezing and exposure to extreme heat and direct sunlight, conditions which will cause premature • Excessive mixing with an elec- tric drill can cause undesirable finished surface appearance. ProForm® is a registered trademark of National Gypsum Properties, LLC.

APPLICABLE STANDARDS AND REFERENCES National Gypsum Company, Gypsum Construction Guide Pro Form BRAND, Dry wall Finishing Products Construction Guide APPROXIMATE DRYING TIMES Note: R.H. = Relative Humidity D = Days (24 hour period) H = Hours The chart above is a helpful guide in determining approximate drying times for joint compounds under a variety of humidity/temperature conditions. Shaded area is below the minimum application temperature requirement of 50° and is not recommended for the application of joint compound. COMPOSITION & MATERIALS Installation of Taping Joint Com- pound should be...