PROFORM® BRAND TAPING LITE READY MIX JOINT COMPOUND National Gypsum Company Technical Information: Internet Home Page: ProForm® BRAND Taping Lite Ready Mix Joint Compound vinyl base compound that may be used directly from BASIC USES Taping Lite Joint Compound is a lightweight taping compound that offers the same benefits • Lightweight. Approximately 40% lighter than standard taping compound. • Excellent adhesion/bond. • Great for use in taping tools. • Ready to use right from the • Low VOC content - Less than GREENGUARD CERTIFIED Taping Lite Ready Mix Joint Indoor Air Quality Certified® ♦ Protect from freezing and exposure to extreme heat and direct sunlight, conditions which will cause premature Storage life varies with climatic under good conditions. Store compound away from extreme cold or heat to avoid premature aging. Regularly check production dates, and rotate inventory on a first-in, first-out plan. If Taping Lite Joint Compound freezes, allow material to thaw at room temperature for at least 24 hours. When thawed, turn container 15 minutes. Turn pail right immediately remix with an electric drill. Taping Lite Joint Compound should be lump free and ready to use within 1 minute. Discard all Taping Lite Joint Compound that does not remix to a lump free consistency. ^^^i professional Formula WUJoint Compound VIJoint Compel • ProForm Joint Tape • Cornerbead, trims, casing • Multi-Flex Tape • E-Z Strip control joints or .093 zinc control joints (Continued next page) Indoor Air Quality Certified ProForm® is a registered trademark of National Gypsum Properties, LLC.

TECHNICAL DATA PACKAGING & COVERAGE ^Coverage varies with number of cornerbeads and trims used. APPLICABLE STANDARDS AND REFERENCES National Gypsum Company, Gypsum Construction Guide ProForm BRAND, Drywall Finishing Products Construction Guide APPROXIMATE DRYING TIMES Note: R.H. = Relative Humidity D = Days (24 hour period) H = Hours The chart above is a helpful guide in determining approximate drying times for joint compounds under a variety of humidity/temperature conditions. Shaded area is below the minimum application temperature requirement of 50° and is not recommended for the application...