Catalogs >
National Gypsum >
ProForm Perfect Spray Texture

ProForm Perfect Spray Texture
2Pages

Catalog excerpts

PROFORM® BRAND PERFECT SPRAY* National Gypsum Company Technical Information: Internet Home Page: ProForm® BRAND Perfect Spray® is a decorative texture with aggregate, designed for spray coarse, medium and fine BASIC USES Perfect Spray's white, bold texture effectively hides minor surface defects and irregularities. Perfect Spray readily mixes with water to application control desired. TECHNICAL DATA PACKAGING & COVERAGE Water Ratio Aggregate Size *Coverage varies with selected textures. APPLICABLE STANDARDS National Gypsum Company, Gypsum Construction Guide ProForm BRAND, Drywall Finishing Products Construction Guide COMPOSITION & MATERIALS Diatomaceous Earth Perfect Spray Perfect Spray Installation of Perfect Spray should be consistent with noted standards and referenc- In cold weather (outside tem- temperatures within the build- during spray operations and until sprayed surfaces have fully dried. Adequate ventilation should be provided to eliminate excess Gypsum board: Surfaces, including joint-treated areas, must be smooth, clean and dry. First apply a coat of seal- ing primer. Allow primer to adequate drying conditions after application. Primer is to minimize sagging of gypsum difference in sheen on ceiling water. Use a piston pump or Mono-type pump with a I.D. material hose. A hopper- type gun with adequate air supply is also suitable. Typical textures. Mask appropriate areas before spraying and promptly remove overspray from unprotected surfaces (Continued next page) Submittal Approvals: (Stamps or Signatures)

Open the catalog to page 1

afterward. Follow the instruc- tions of the spray equipment second coat is desired, allow the first coat to dry Note: Gypsum board ceiling surfaces to be decorated with water-thinned spray texture framing. Framing shall not ex- ceed 16" o.c. for Gold Bond® BRAND 1/2" Regular Gypsum High Strength™ Ceiling Board and Gold Bond® BRAND 5/8" Gypsum Board. Concrete: Allow concrete to cure for at least 28 days. Clip protruding wire ends and spot with rust-inhibitive primer. Remove all form oil, grease water-soluble material. Grind down any form ridges and level any remaining uneven- ness with...

Open the catalog to page 2