
URBAN CX A blend of classic design and modern technology LIGHT WITH STYLE: MS LUX AMBIENT LIGHTING The combination of classic design with modern technology creates an elegant and durable light option for different environments. This light fitting offers high efficiency, long life and minimal environmental impact thanks to advanced LED technologies. The old-town design adapts to parks, trails and squares, while the black colour of the housing provides a refined look that easily fits into different architectural styles. M SAN Grupa d.o.o., Dugoselska ulica 5, 10372 Rugvica, HR www.mslux.eu
Open the catalog to page 1Light characteristics Certificates, Standards Resistance to water and dust IP 66 Possibility of extending warranty Yes Colour rendering index (CRI) > 70, (80 option) Protective cover PMMA, PC ULOR 0% (full cutoff) Lens type Individual Electrical characteristics Control Input voltage 220-240V AC Autonomous control AstroDim Operating frequency 50-60Hz Luminous flux control DALI-2 Power factor > 0.95 Control range 10-100% Electrical protection class Class I Dim-to-off Yes Ambient temperature -35°C +55°C Built-in CLO system (option) Yes Overvoltage protection (kV) CM - 10kV Wireless driver programming...
Open the catalog to page 2URBAN CXOther characteristics Model Light fitting power Luminous flux Efficacy CCT CRI Width (mm) Length (mm) Height (mm) Base diameter Mass (kg) Data subject to change. Last modified: 12-Oct-2023
Open the catalog to page 3URBAN CX Connecting and disconnecting of the light fitting and all its parts MUST be done in a voltage-free state. 1. The light fitting power cord comes out of the light fitting door, where: • Grounding (GND) - yellow green 2. Bring the LV mains connection cable to the light fitting door. If an additional bracket (arm) is used, run the cable through the bracket (arm). The light fitting is connected directly to the mains with the included 3x1mm2 cable (rubber) or via the WAGO 294-5013 connector. 3. Using terminal blocks, connect the phase (L), zero (N) and grounding (GND) wires correctly. The...
Open the catalog to page 4URBAN CX TYPICAL LIGHT DISTRIBUTION L17 Data subject to change. Last modified: 12-Oct-2023
Open the catalog to page 5URBAN CX Light fitting maintenance Maintenance must be done in a voltage-free state, protected against accidental switching on. If maintenance is carried out without dismantling, the light fitting must not be opened during bad weather to avoid condensation of moisture inside the light fitting. Before closing the protective cover, the interior of the light fitting should be wiped with a dry soft cloth. In doing so, it is necessary to check the condition of the protective cover gasket and replace it if damaged. Installation and maintenance The light fittings may only be installed/dismantled by...
Open the catalog to page 6URBAN CX A blend of classic design and modern technology M SAN Grupa d.o.o., Dugoselska ulica 5, 10372 Rugvica, HR www.mslux.eu
Open the catalog to page 7