LED8W350iN-01

Product catalog summary

Ordering Information
This section provides fields for specifying the date, quantity, project, and type of product when placing an order for the LED8W350iN-01 driver with a B driver enclosure.

Important Notes
1. Avoid installing an on-off switch on the output side of a constant current LED driver to prevent fixture damage and warranty voidance.
2. Follow MP Lighting's wiring instructions: series wiring for constant current drivers and parallel wiring for constant voltage drivers. Improper installation voids the warranty.

Specifications

Model: LED8W350iN-01
Type: Constant Current
Power: 8W, 350mA, non-dimmable
Input Voltage: 100-240V AC
Location: Suitable for damp and dry locations

Dimensions
The driver dimensions are 2-5/8” x 7/8” x 1-3/8”, and with enclosure, it measures 6-1/4” x 5-1/8” x 2”.

Performance

Input Voltage: 100~240V AC, 50/60 Hz
Output Voltage: 3~36V DC
Current: 350mA Constant
Efficiency: 68%
Power Factor: 0.9 minimum

Controls
The driver is non-dimmable.

Recommended Load
Typically used for 1W LED fixtures with a load range of 2 to 7 fixtures.

Application
Approved for damp and dry locations with an ambient temperature range of -20°C to 65°C. The driver includes short circuit and overload protection.

Wiring Diagram
Illustrates the non-dimming setup for 2-7 x 1W LED lighting fixtures wired in series.

Catalog excerpts

LED8W350iN-01 CONSTANT CURRENT 8W, 350mA, non-dimmable, 100-240V AC Input Damp, and Dry location Ordering Information Clear Form Specifications LED Driver | Example Code: LED8W350iN-01-B Product Important Notes Warranty Notes & Disclaimer MP Lighting reserves the right, at its sole discretion, at any time and without notice, to make improvements and innovations to any of our products. Consult MP Lighting website for further details. 1. Do not install on-off switch at the output (load) side of a constant current LED driver as it will damage the fixture(s) and will void the warranty on both driver and fixture(s). 2. Fixtures must be wired as per MP Lighting's instruction (series wiring for constant current driver and parallel wiring for constant voltage drivers.) Failures due to improper installation will void warranty. Dimensions Driver Driver with Enclosure (EBX-160-ZP) 2-5/8” 66mm driver MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 1

LED8W350iN-01 CONSTANT CURRENT 8W, 350mA, non-dimmable, 100-240V AC Input Damp, and Dry location Performance Input Power Factor: 0.9 minimum. Controls Dimming Protocols Dimming Range Recommended Load Driver Load Typically used for 1W LED fixtures with the load below: Systems Input Voltage System Dimming Option Application Environments Damp / Dry Location approved. Ambient Temperature Case Temperature Driver Protection Short Circuit & Overload protection Case Material Non-conductive white plastic. MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 2

Wiring Diagram Non-Dimming | For use with 2-7 x 1W LED lighting fixtures (350mA), wired in series Non-Dimmable Driver MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 3

All MP Design Inc. catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list