LED50W200iX-01

Product catalog summary

Ordering Information
This section provides placeholders for date, quantity, project, note, and type, indicating the customizable nature of the order.

Important Notes
1. Avoid installing an on-off switch on the output side of a constant current LED driver to prevent fixture damage and warranty voidance.
2. Follow MP Lighting's wiring instructions: series wiring for constant current drivers and parallel wiring for constant voltage drivers to maintain warranty validity.

Specifications

Product Code: LED50W200iX-01-B
Driver Type: Constant Current
Power: 50W, 200mA
Dimming: DMX dimming, 120-277V AC Input
Location Suitability: Damp and Dry locations

Dimensions
Details the dimensions of the driver and driver with enclosure, providing measurements in both inches and millimeters.

Performance

Input Voltage: 120~277V AC, 50/60 Hz
Output Voltage: 120-250V DC
Power Factor: Minimum 0.95
Efficiency: Typical 86%
Dimming Protocols: 0~10V dimming with a range of 0.1%~100%
Recommended Load: Compatible with RGB-W fixtures, typically used for 2W LED fixtures

Application
Approved for damp and dry locations with an ambient temperature range of -20~50°C (-4~122°F) and a maximum case temperature of 80°C (176°F). The driver includes short circuit, overload, and over-voltage protection.

Wiring Diagram
Illustrates the dimming setup for use with 1-10 x 2W LED lighting fixtures (200mA), wired in series, highlighting the connection to a dimmable driver.

Catalog excerpts

LED50W200iX-01 CONSTANT CURRENT 50W, 200mA, DMX dimming, 120-277V AC Input Damp, and Dry location Ordering Information Clear Form Specifications LED Driver | Example Code: LED50W200iX-01-B Product Important Notes Warranty Notes & Disclaimer MP Lighting reserves the right, at its sole discretion, at any time and without notice, to make improvements and innovations to any of our products. Consult MP Lighting website for further details. 1. Do not install on-off switch at the output (load) side of a constant current LED driver as it will damage the fixture(s) and will void the warranty on both driver and fixture(s). 2. Fixtures must be wired as per MP Lighting's instruction (series wiring for constant current driver and parallel wiring for constant voltage drivers.) Failures due to improper installation will void warranty. Dimensions Driver Driver with Enclosure (EBX-160-ZP) 5-1/8” 130mm MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 1

LED50W200iX-01 CONSTANT CURRENT 50W, 200mA, DMX dimming, 120-277V AC Input Damp, and Dry location Performance Input Power Factor: 0.95 minimum. Controls Dimming Protocols Dimming Range Recommended Load Driver Load Typically used for 2W LED fixtures with the load below: Compatible with RGB-W fixtures. Systems Input Voltage System Dimming Option Application Environments Damp / Dry Location approved. Ambient Temperature Case Temperature Driver Protection Short Circuit, Overload & Over-voltage protection Case Material MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 2

Wiring Diagram Dimming | For use with 1-10 x 2W LED lighting fixtures (200mA), wired in series Dimmable Driver MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 3

All MP Design Inc. catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list