LED4W700iN-01

Product catalog summary

Ordering Information
This section provides fields for specifying the date, quantity, project details, and type of product when placing an order for the LED4W700iN-01 driver with a B driver enclosure.

Important Notes
MP Lighting reserves the right to make product improvements without notice. It is crucial not to install an on-off switch on the output side of a constant current LED driver to avoid damage and warranty voidance. Proper wiring as per MP Lighting's instructions is essential to maintain warranty validity.

Specifications
The LED4W700iN-01 is a constant current, non-dimmable LED driver with a 4W, 700mA output and an input voltage range of 100-277V AC. It is suitable for damp and dry locations and complies with UL Class 2 standards.

Dimensions
The driver dimensions are provided, including both the driver alone and with the enclosure (EBX-160-ZP).

Performance
The driver operates with an input voltage of 100-277V AC and outputs 2.8-6.5V DC with a power factor of at least 0.9 and typical efficiency of 80%. It is not dimmable and is recommended for use with 1W LED fixtures.

Application
The driver is approved for damp and dry locations, with an ambient temperature range of -25°C to 85°C. It includes protections against short circuits, overload, and over-voltage. The case is made of non-conductive black plastic and weighs 40g.

Wiring Diagram
The diagram illustrates the non-dimmable wiring setup for 1-2 x 1W LED lighting fixtures (700mA) in series.

Catalog excerpts

LED4W700iN-01 CONSTANT CURRENT 4W, 700mA, non-dimmable, 100-277V AC Input Damp, and Dry location (UL Class2) Ordering Information Clear Form Specifications LED Driver | Example Code: LED4W700iN-01-B Product Important Notes Warranty Notes & Disclaimer MP Lighting reserves the right, at its sole discretion, at any time and without notice, to make improvements and innovations to any of our products. Consult MP Lighting website for further details. 1. Do not install on-off switch at the output (load) side of a constant current LED driver as it will damage the fixture(s) and will void the warranty on both driver and fixture(s). 2. Fixtures must be wired as per MP Lighting's instruction (series wiring for constant current driver and parallel wiring for constant voltage drivers.) Failures due to improper installation will void warranty. Dimensions Driver Driver with Enclosure (EBX-160-ZP) 1-15/32" 37.5mm MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 1

LED4W700iN-01 CONSTANT CURRENT 4W, 700mA, non-dimmable, 100-277V AC Input Damp, and Dry location (UL Class2) Performance Input Power Factor: 0.9 minimum. Controls Dimming Protocols Dimming Range Recommended Load Driver Load Typically used for 1W LED fixtures with the load below: Systems Input Voltage System Dimming Option Application Environments Damp / Dry Location approved. Ambient Temperature Case Temperature Driver Protection Short Circuit, Overload & Over-voltage protection Case Material Non-conductive black plastic. MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 2

Wiring Diagram Non-Dimming | For use with 1-2 x 1W LED lighting fixtures (700mA), wired in series Non-Dimmable Driver MP Lighting © | www.mplighting.com | [email protected] | 604.708.1184

Open the catalog to page 3

All MP Design Inc. catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list