LED10W600iP-01
3Pages

LED10W600iP-01 CONSTANT CURRENT 10W, 600mA, ELV dimmable, 120V AC Input Damp, and Dry location (UL Class2) Ordering Information Clear Form Specifications LED Driver | Example Code: LED10W600iP-01-B Product Important Notes Warranty Notes & Disclaimer MP Lighting reserves the right, at its sole discretion, at any time and without notice, to make improvements and innovations to any of our products. Consult MP Lighting website for further details. 1. Do not install on-off switch at the output (load) side of a constant current LED driver as it will damage the fixture(s) and will void the warranty on both driver and fixture(s). 2. Fixtures must be wired as per MP Lighting's instruction (series wiring for constant current driver and parallel wiring for constant voltage drivers.) Failures due to improper installation will void warranty. Dimensions Driver Driver with Enclosure (EBX-160-ZP) MP Lighting © | www.mplighting.com | info@mplighting.com | 604.708.1184

LED10W600iP-01 CONSTANT CURRENT 10W, 600mA, ELV dimmable, 120V AC Input Damp, and Dry location (UL Class2) Performance Input Power Factor: 0.9 minimum. Controls Dimming Protocols ELV dimming at 120V only. Can be used in both dimming & non-dimming systems. Dimming Range Recommended Load Driver Load Typically used for 6W or 8W LED fixtures with the load below: Systems Input Voltage System Dimming Option Application Environments Damp / Dry Location approved. Ambient Temperature Case Temperature Driver Protection Short Circuit, Overload & Over-voltage protection Case Material MP Lighting © |...

Wiring Diagram Dimming | For use with 1 x 6W or 1 x 8W LED lighting fixtures (600mA), wired in series Dimmable Driver Dimmable Driver Triac/ELV Dimming LED Lighting Fixture 600mA Non-Dimming | For use with 1 x 6W or 1 x 8W LED lighting fixtures (600mA), wired in series 1 Dimmable Driver Dimmable Driver Triac/ELV Dimming LED Lighting Fixture 600mA MP Lighting © | www.mplighting.com | info@mplighting.com | 604.708.1184