INSTALLATION GUIDE - SK CONVECTORS fig. i: COMPONENTS OF THE SKIRTING CONVECTOR: Anti-vibration pad A skirting-type heating unit which uses the convection principle. Since the heater fully uses physical laws of thermodynamics it represents one of the most efficient methods of interior heating. Benefits of skirting convectors with fan: High output > Possibility of using forced convection for heating (with fan) > Silent operation > Low hot water consumption > Very short response time > Design > A great advantage of these convectors is the possibility of installation in a skirting (under kitchen cabinets, stairs, wardrobes, etc.). This advantage is particularly practical in applications where we do not want to disturb the aesthetic experience of the interior with wall-mounted or free-standing convectors or other heating units, and where sufficient heating output is required at the same time. Each position in the table corresponds to Figure No. 1 - see next page. 1. TROUGH - an all-aluminum structure which holds all components (AIMg3). 2. HEAT EXCHANGER - copper pipes with pressed--on aluminum fins through which the heating water flows. 3. FAN - used for forced convection. 4. METAL COVER - used as a lid of the trough (position 1) and protects all components located in it from damage. 5. DIRECTIONAL METAL PLATE - improves the convector output thanks to ideal air flow around the heat exchanger. 6. FRONT GRILLE - the only visible part after installation. 7. GRILLE SIDE PLATE - limits the space (horizontally) for placement of the grille. 8. EB CONTROL UNIT - fan motor control unit. 9. TEMPERATURE SENSOR - heat exchanger temperature sensor 10. CABLE GROMMET - intended for 12VAC power supply cable. 11. GUIDE BAR - used for exact positioning of the convector. 12. RUBBER ANTI-VIBRATION RING - used for attenuation of vibrations and for mounting of the metal covers and fan modules. 13. SCREW - for fixing the guide bars (position 11) to the floor, step. 14. SCREW ANCHOR - for fixing the screw in concrete floor. 15. HOSE - the bellows hose is a stainless hose intended for fitting connection to the convector exchanger. 16. STRAIGHT BALL VALVE - a valve used to shut off the heating water supply to the convector. 17. CONTROL SCREW FITTING - a valve that controls/ adjusts heating water flow. 18. GASKET - seals joints between valves, hoses, and exchangers (KLINGERSIL C4400). MINIB, a.s. recommends this sealing as the optimal sealing solution because other materials (rubber, NBR, silicon) do not provide the required sealing characteristics. Use: dry environment, according to the specification. > Maximum operating pressure: 1 MPa. > Maximum operating temperature: 90 °C. > Operating medium: water. The use of other media is prohibited. Water may not be mixed with other substances, such as antifreeze fluids! > Environment: interiors with temperatures ranging between +5 °C and +40 °C. > Power supply: 12 V AC from a suitable transformer for the given environment and convector fan types.

fig. 2: Minimum installation dimensions: height 117 mm; width 510 mm; depth – heating water supply must be taken into account. fig. 3: The installation template is symmetrical; the longer edge (507 mm) copies the front surface of the convector (front grille). 5. CONNECTION OF THE FITTINGS Connect the fittings using the supplied standard accessories (direct connection – in the rear part of the convector). Connect individual inlet and outlet valves. The water inlet to the convector is provided with a ball valve (standard supply) enabling the shutting off of the heating water supply in the event...