Catalogs >
MAPEI >
WALLGARD BARRIER

WALLGARD BARRIER
1 / 4Pages

Catalog excerpts

ti r affirie GrBar rd Ga ll a W Reversible graffiti-resistant protective barrier WHERE TO USE • rotection of marble, granite and other natural P stone facings against spray-painted graffiti. • rotection for fair-faced surfaces. P Some application examples On all surfaces that are potential targets for graffiti, such as: • ll types of natural stone facings; a • rick or concrete block facings; b • oncrete facings; c • enders resistant to high pressure cleaning with r hot water; • re-painted wood and iron structures. p TECHNICAL CHARACTERISTICS WallGard Graffiti Barrier is a water emulsion of polymer waxes specifically formulated for reversible protection of facings against graffiti. WallGard Graffiti Barrier fills surface pores without affecting permeability, creating a repellent barrier against oils and water that prevents graffiti from penetrating deeply. After application, WallGard Graffiti Barrier forms a film that has very little effect on the appearance of the treated surface. To check its effect on the surface finish, we recommend testing the product on a small area. To get the best result apply the product right up to the string-course, expansion joints or guttering. WallGard Graffiti Barrier is easily removable using hot water (about +80°C) in a high pressure cleaner. RECOMMENDATIONS • o not use WallGard Graffiti Barrier to D consolidate surfaces. • o not dilute WallGard Graffiti Barrier with D solvents or water. • o not apply WallGard Graffiti Barrier on D non-absorbent surfaces such as polished ma

Open the catalog to page 1

• Do not apply WallGard Graffiti Barrier on substrates that are saturated with water or when rain is imminent. • Do not apply WallGard Graffiti Barrier at temperatures below +5°C and above +35°C. and should not be diluted with water or solvents. Application procedure WallGard Graffiti Barrier can be applied with brush, roller, spray or airless gun. The latter are preferable for rough or irregular surfaces. For thorough impregnation WallGard Graffiti Barrier should be applied to saturation in a single coat. On very porous surfaces, apply a second coat, if needed, 20 minutes later at +20°C....

Open the catalog to page 2

TECHNICAL DATA (typical values) PRODUCT IDENTITY milky white APPLICATION DATA Dilution rate: Application temperature: Consumption (kg/m²): 0.03-0.15 according to the porosity of the substrate Using a high-pressure cleaner on Carrara marble treated with WallGard Graffiti Barrier FINAL PERFORMANCE VOC content of ready-to-use product (European Directive 2004/42/EC) (g/l): WARNING Although the technical details and recommendations contained in this product data sheet correspond to the best of our knowledge and experience, all the above information must, in every case, be taken as merely...

Open the catalog to page 3