Two-component, 100% polyurethane water-based varnish with high resistance to wear and abrasion with low emission of volatile organic compounds (VOC) for wooden floors. Suitable for floors subject to extremely high pedestrian use WHERE TO USE Highly protective, wear and abrasion-resistant finish for solid and pre-sanded wooden floors and wooden floors requiring repair. Suitable for use in civil and commercial environments, including those subject to extremely high pedestrian traffic (public offices, shopping centres, airports, exhibition halls, etc.). TECHNICAL CHARACTERISTICS Ultracoat High Traffic is a two-component, waterbased varnish formulated with 100% aliphatic (nonyellowing) polyurethane resins, characterised by an excellent level of resistance to abrasion and scuff marks from rubber-soled shoes never previously achieved with other water-based products. It also gives parquet floors an attractive “natural wood” finish (0 gloss). Floors treated with this varnish have a natural, even finish, and their cleanability is very similar to that of impregnation cycles with oil and wax. If applied directly without a base product, it considerably enhances the colour of the parquet and does not yellow over the years. Ultracoat High Traffic is available in 0 gloss - 10 gloss 30 gloss - 60 gloss. RECOMMENDATIONS • o not use Ultracoat High Traffic at temperatures D lower than +10°C. • o not use on external surfaces. D • se only clean containers and tools. U • n types of wood with a high content of extracts, we O recommend checking that the product is compatible or applying Ultracoat Universal Base or Ultracoat Premium Base as a first coat. • Completely remove all traces of previous treatments in order to obtain an even finish. • Protect treated surfaces from direct sunlight and draughts for the first 3 hours after application. • Leftovers of the product must not be put back into its container. Partially-used containers must not be stored for very long periods. • At high temperatures, we recommend diluting the product with 10% water or with Ultracoat EL (Dir. 2004/42/EEC). Protect from frost. For transport at low temperatures, use vehicles with temperaturecontrolled units. Preparation of the product Shake component A before use, insert the filter in the cap of the can and pour the product into the special basin. At high temperatures, dilute the product with up to a maximum of 10% clean water or Ultracoat EL (Dir. 2004/42/EEC). Add component B at a ratio of comp A : comp B = 10 : 1 (in volume) and mix thoroughly until completely blended. Apply the mix within 2 hours of blending. If only a part of component A is used, remove the filter before closing the can and rinse it thoroughly

TECHNICAL DATA (typical values) PRODUCT IDENTITY

APPLICATION PROCEDURE Sand wooden floors with coarse and medium-grained sandpaper and remove all traces of dust with a vacuum cleaner. Grout cracks and irregularities in the surface with Ultracoat Aqua Plus or Ultracoat Binder, according to the instructions contained in the product’s relative Technical Data Sheet. Remove all traces of dust after sanding. Apply a first, even coat of Ultracoat High Traffic or a base coat of Ultracoat Universal Base or Ultracoat Premium Base with a roller (Ultracoat Roller Plus). If Ultracoat High Traffic is used for the first coat, sand the surface after 8 hours...

AMPf/ BUILDING THE FUTURE ■O Q) .C <o 3 o-o in \p c 3 o o \p <u (0 « ° 1.1