IN COMPLIANCE WITH EUROPEAN STANDARD SURFACE PROTECTION SYSTEMS FOR CONCRETE Fast-setting light grey-coloured fine mortar for repairs and finishing of concrete and renders WHERE TO USE For repairing and finishing of porous or chipped cement-based surfaces. For thicknesses greater than 3 mm, adding 30% aggregates with a maximum diameter of 2 mm is recommended. Some application examples • vening out surface imperfections in prefabricated E concrete, such as interlocking panels, beams and pillars. Planitop 100 meets the requirements defined by EN 1504-9 (“Products and systems for the protection and repair of concrete structures - Definitions, requirements, quality control and evaluation of conformity - General principles for the use of products and systems”) and the minimum requirements claimed by EN 1504-2 coating (C) (“Surface protection systems for concrete”) according to MC and IR principles. • inishing of cement renders or lime and cement F mortar before painting with Elastocolor range of products. • mall repairs to precast concrete sections damaged S while being moved. • apid finishing of concrete facings repaired with R products of the Mapegrout line. TECHNICAL CHARACTERISTICS Planitop 100 is a one-component mortar based on special cement binders, selected fine grain aggregates, additives and polymers manufactured according to a formula developed in the MAPEI research laboratories. When mixed with water, Planitop 100 produces a runny mortar that is easily applied even vertically up to 3 mm thick per coat. Because of its high synthetic resin content, Planitop 100 has excellent adhesion to all cementbased surfaces and forms a compact and mechanically strong layer after hardening (1 to 1.5 hours at +20°C). N.B. Planitop 100 has a shelf life of 12 months when stored in a dry place. With time, however, setting may be slower, but Planitop 100’s final mechanical characteristics will remain unchanged. RECOMMENDATIONS • Do not use Planitop 100 to repair large surfaces. Use products from the Mapegrout range. • Do not add lime, cement or gypsum to the mix. • Do not add water to a mix that has already begun APPLICATION PROCEDURE Preparing the substrate Substrates must be sound and free of dust, loose materials, and form-release agents. Reinforcing bars must have rust removed and then be treated with Mapefer or Mapefer 1K.

Planitop 100: ne component, quick-setting cementitious mortar for protecting concrete; o conforms with the requirements of EN 1504-2 coating (C), MC and IR principles TECHNICAL DATA (typical values) PRODUCT IDENTITY Consistency: light grey Maximum size of aggregate (mm): Bulk density (kg/m³): APPLICATION DATA OF PRODUCT (at +20°C - 50% U.R.) Colour of mix: Mixing ratio: 1 00 parts of Planitop 100 with 26-27 parts of water (6.5-6.75 litres of water per 25 kg sack) thixotropic - trowellable Recommended minimum and maximum thickness (mm) – applied neat: – ix added with 30% of sand with max. 2 mm...

Saturate concrete or other porous materials with water. Wait for the excess water to evaporate before applying Planitop 100. To facilitate the elimination of free water, use compressed air or a sponge. In no case can the mortar be applied on substrates that have a film of surface water. Preparing the mix Finishing coat from 1 to 3 mm thick • Pour a 25 kg bag of Planitop 100 into a receptacle containing 6.5-6.75 litres of clean water while mixing continuously with an agitator at low speed until a homogeneous lump free mix is obtained. Repairs from 3 to 30 mm thick • After mixing Planitop 100 with...

Any reproduction of texts, photos and illustrations published here is prohibited and subject to prosecution