d n 0 a 2 b 1 eE pP a M PVC tape for waterproofing systems created using liquid membranes WHERE TO USE • aterproofing corners between adjacent walls W and between walls and floors to be treated with Mapegum WPS or Mapelastic AquaDefense. • ealing pipe-work and drains in bathrooms, showers S and kitchens with special Mapeband PE 120 seals. TECHNICAL CHARACTERISTICS Mapeband PE 120 is made from polyester mesh and PVC fabric which is impermeable to water and vapour. Mapeband PE 120 is elastic and deformable. Mapeband PE 120 is also supplied in special shapes for use on internal and external of corners, and as seals for pipe-work in bathrooms, kitchens, showers etc. and drains. RECOMMENDATIONS • o get a perfect seal in corners, use the special T pre-shaped Mapeband PE 120 pieces. • o get a perfect seal around pipe-work, use the T special Mapeband PE 120 seals. APPLICATION PROCEDURE Apply a thin layer at least 1 mm thick of Mapegum WPS or Mapelastic AquaDefense to the sides of the corners and expansion joints to be waterproofed with Mapeband PE 120. Embed the mesh part of Mapeband PE 120 tape or special shaped pieces (angle pieces and seals) in the layer of Mapegum WPS or Mapelastic AquaDefense while it is still fresh with a smooth trowel. Mapegum WPS or Mapelastic AquaDefense must also come into contact with at least a few mm of the PVC part of Mapeband PE 120. Joints between adjacent pieces of Mapeband PE 120 must be bonded using Adesilex PVC HP, solvent resin-based adhesive. PACKAGING • 10 m and 50 m rolls, 120 mm wide. • 90° and 270° angle pieces (boxes of 25). • Seals for 120x120 mm through holes (boxes of 25) and 425x425 mm through holes (boxes of 10). STORAGE We recommend keeping Mapeband PE 120 in its original packaging when storing on site. SAFETY INSTRUCTIONS FOR PREPARATION AND APPLICATION Mapeband PE 120 is an article and referring to the current European regulations (Reg. 1906/2007/CE REACH) does not require the preparation of the material safety data sheet. During use it is recommended to wear gloves and goggles and follow the safety requirements of the workplace. PRODUCT FOR PROFESSIONAL USE. N.B. Whilst we try to ensure that any advice, recommendations or information given in our literature is accurate and

TECHNICAL DATA (typical values) PRODUCT IDENTITY approx. 0.70 Resistance to water under pressure (bar): Elongation at break (according to ISO 527-1) (%): In service temperature range: Chemical resistance for continuous containment of the following aggressive products (7 days at +23°C): – hydrochloric acid (3%): – sulphuric acid (35%): – citric acid (100 g/l): – lactic acid (5%): – sodium hypochlorite (0.3 g/l): – salt water (20 g/l of sea salt): good good good good good good SPECIAL MAPEBAND PE 120 SHAPED PIECES Positioning Mapeband PE 120 in an omega pattern in an expansion joint correct, we...