r lo oF cS o tante ss la a E R s es d n ickorce ing h h teinf coat Hige-r ric r fib ome t las e GOOD ELASTICITY HIGH FILLING PROPERTIES WHERE TO USE Ready-to-use, intermediate smoothing and filling compound, particularly suitable for application by trowel for embedding reinforcement mesh (Elastocolor Net) and to improve the homogeneity of the substrate and provide flexibility for the Elastocolor finish. Some application examples • ntermediate elastomeric high-filling and smoothing I compound with a rustic finish, to even out irregularities in the substrate before coating with Elastocolor Paint. • ntermediate plasto-elastic coat ideal for embedding I Elastocolor Net reinforcing mesh. • ntermediate elastomeric coat to increase the total I thickness and overall flexibility of the Elastocolor system. • lastocolor Rasante SF, applied with a brush, E honeycomb-pattern sponge roller or short-haired roller or by spray, diluted with 5-10% of water, may also be used as a flexible filling and finishing coat similar to quartz paint. TECHNICAL CHARACTERISTICS Elastocolor Rasante SF is a cement-free, elastomeric acrylic emulsion-based fibrous, intermediate material admixed with graded sand, blended to a formula developed in MAPEI’s own Research and Development Laboratories. If the substrate has widespread cracking less than 1 mm thick, reinforce Elastocolor Rasante SF with Elastocolor Net mesh which, after drying, forms a permanent, flexible reinforcement which mimics the expansion of the substrate. Elastocolor Rasante SF meets the main requirements of EN 1504-9 (“Products and systems for protecting and repairing concrete structures: definitions, requirements, quality control and conformity assessment. General principles for the use and application of systems”), and the requirements of EN 1504-2 (“Protection systems for concrete surfaces”) for class: products for protecting IN COMPLIANCE WITH EUROPEAN STANDARD PI-MC-IR SURFACE PROTECTION SYSTEMS FOR CONC

TECHNICAL DATA (typical values) Conforms to the following standards: - products certified according to EN 1504-2 (Surface protection systems for concrete), 2+ and 3 system; - classes according to EN 1504-2: products for protecting surfaces - coating - protection against the risk of penetration (1.3) (ZA.1d) + control of humidity (2.2) and increase in resistivity (8.2) (ZA.1e) (C, PI-MC-IR principles) PRODUCT IDENTITY surfaces - coating (C) - protection against the risk of penetration (1.3) (protection against ingress, PI) (ZA.1d) + control of humidity (2.2) (moisture control, MC) and increase...

GREEN INNOVATION Elastocolor Rasante SF with 5% of water. When diluting the product make sure it is thoroughly blended. Use a drill at low speed for mixing if necessary. When preparing only partial quantities, we recommend mixing Elastocolor Rasante Sf as is in its original container before taking out the quantity required. Application of the product Elastocolor Rasante SF can be applied by metal trowel or brush, roller or air-spraying (not airless), on dried primer. If more than one coat of Elastocolor Rasante SF is required, wait at least 24 hours between each coat, and in all cases, only when...

PERFORMANCE CHARACTERISTICS FOR CE CERTIFICATION ACCORDING TO EN 1504-2, 2+ AND 3 SYSTEM CLASSES ZA.1d + ZA.1e (C, PI - MC - IR principles) STANDARD TEST RESULTS AND CONFORMITY TO REQUIREMENTS EN ISO 1770 FURTHER PERFORMANCE CHARACTERISTICS ACCORDING TO EN 1504-2 REGARDING REQUIREMENTS FOR CLASSES ZA.1d + ZA.1e RESULTS AND CONFORMITY TO REQUIREMENTS