Catalogs >
Mageba >
LASTO ® WALL G

LASTO ® WALL G
4Pages

Catalog excerpts

Wall bearings prevent the flanking transmission of footstep noise through the wall base. Principle LASTO®WALL G are manufactured from styrene butadiene rubber (SBR) granulate. Our special production process generates permanently elastic LASTO®WALL G, whose good acoustic characteristics and defined spring compression perform well in both low and high load areas. The LASTO®WALL G has been developed to effectively interrupt the transmission of footstep noise vertically through the masonry. If wall bearings are used consistently throughout a building, and other sound transmission vectors are eliminated, this can significantly improve the quality of living conditions. LASTO®WALL G can be used when increased sound insulation in a building is desired. This can be the case, for example, in living rooms or bedrooms, meeting rooms and offices. The product is suitable for acoustic insulation in load-bearing and non-load-bearing walls. Thanks to its flexibility, which permits slight horizontal deformations and rotations, the wall bearing can also be used as a separator bearing. The rubber granulate has sufficient elasticity to effectively reduce restraint forces.

Open the catalog to page 1

Acoustic Insulation The technical characteristics of the wall bearings make them unique in terms of acoustic insulation. LASTO®WALL G form an elastic intermediate layer which interrupts the transmission of vibrations caused by impact sound, which would otherwise be transmitted by reverberant construction elements and spread throughout the structure almost without damping. The Swiss standard SIA 181 defines the requirements for acoustic insulation. Normal construction methods are usually sufficient to achieve the minimum requirements. However, if there are more strict requirements for...

Open the catalog to page 2

Characteristics The LASTO®WALL G stands out as a result of the following characteristics: Highly stressable, up to 5 N/mm² Permanently elastic Durable Does not deteriorate Resistant to damp and water Thermal conductivity 0.18 W/mK Moulded density approx. 720 kg/m³ Working temperature: -20°C – +115°C Ultimate elongation 45% ±10% (UNI EN 12311) Dynamic stiffness: 70 ±2 MN/m³ (UNI EN 29052 / 1) Sound reduction: ≥ 23 dB (UNI EN140-6 / 717-2) LASTO®WALL G with projection into room Spring compression curves The stress in the LASTO®WALL G increases proportionally to deformation. The following...

Open the catalog to page 3

Tender Use as wall bearing Delivery and jointless installation of wall bearings of flat surfaces, with approx. 15mm projection on the side of the walls to be plastered. Use as slab bearing Delivery and jointless installation of slab bearings on 10-20mm smooth mortar layer. Type: Thickness: WALL G width: Bearing width: Supplier: Type Thickness: Bearing width: Supplier: LASTO-WALL G G WL 4R 4mm 150mm 180mm mageba sa CH-8180 Bülach Tel.: +41-44-872 40 50 Fax: +41-44-872 41 29 Email: hochbau@mageba.ch www.mageba.ch LASTO-WALL G G WL 4R 4mm 150mm mageba sa CH-8180 Bülach Tel.: +41-44-872 40 50...

Open the catalog to page 4